Related papers: Pre-dewetting transition on a hydrophobic wall: St…
During the Leidenfrost effect, a stable vapor film can separate a hot solid from an evaporating liquid. Eventually, after formation and upon cooling, the vapor layer cannot be sustained and undergoes a violent collapse evidenced by…
We investigate the dynamics of spreading of a small liquid droplet in gas in a one-component simple fluid, where the temperature is inhomogeneous around 0.9Tc and latent heat is released or generated at the interface upon evaporation or…
We construct a phase field model including hydrodynamics and elasticity in one-component systems. It can be used to investigate solid-liquid and liquid-liquid phase transitions. Upon first-order phase transition, a velocity field is induced…
Dewetting of thin liquid films is monitored in situ by atomic force microscopy, results are compared with simulations. The experimental setting is mimicked as close as possible using the experimental parameters including the effective…
In this two-part study we investigate the phase behaviour of a fluid spatially confined in a semi-infinite rectangular pore formed by three orthogonal walls and connected to a reservoir maintaining constant values of pressure and…
We study the solid-on-solid interface model above a horizontal wall in three dimensional space, with an attractive interaction when the interface is in contact with the wall, at low temperatures. The system presents a sequence of layering…
Contrary to common assumptions, a transcritical domain exists during the early times of liquid hydrocarbon fuel injection at supercritical pressure. A sharp two-phase interface is sustained before substantial heating of the liquid. Thus,…
Phase transformations such as freezing typically start with heterogeneous nucleation. Heterogeneous nucleation near a wetting transition, of a crystalline phase is studied. The wetting transition occurs at or near a vapour-liquid transition…
Using discrete molecular dynamics simulations we study the relation between the thermodynamic and diffusive behaviors of a primitive model of aqueous solutions of hydrophobic solutes consisting of hard spheres in the Jagla particles…
A microscopic model of the lipid membrane is constructed that provides analytically tractable description of the physical mechanism of the first order liquid-gel phase transition. We demonstrate that liquid-gel phase transition is…
We examine the profile of a liquid front of a film that is dewetting a solid substrate. Since volume is conserved, the material that once covered the substrate is accumulated in a rim close to the three phase contact line. Theoretically,…
The van der Waals forces across a very thin liquid layer (nanofilm) in contact with a plane solid wall make the liquid nonhomogeneous. The dynamics of such flat liquid nanofilms is studied in isothermal case. The Navier-Stokes equations are…
We argue that for complete wetting at a curved substrate (wall) the wall-fluid surface tension is non-analytic in $R_i^{-1}$, the curvature of the wall and that the density profile of the fluid near the wall acquires a contribution…
We investigate the origin of the density depletion and enhanced density fluctuations that occur in water in the vicinity of an extended hydrophobic solute. We argue that both phenomena are remnants of the critical drying surface phase…
We present a study of the spreading of liquid droplets on a solid substrate at very small scales. We focus on the regime where effective wetting energy (binding potential) and surface tension effects significantly influence steady and…
We study the behavior of very thin liquid films wetting homogeneous planar and spherical substrates. In order to describe a simple fluid at very small scales, we employ a classical density functional theory (DFT). Here, we model a fluid…
The generation mechanism of wall heat flux is one of the fundamental problems in supersonic/hypersonic turbulent boundary layers. A novel heat decomposition formula under the curvilinear coordinate was proposed in this paper. The new…
We study the wetting model, which considers a random walk constrained to remain above a hard wall, but with additional pinning potential for each contact with the wall. This model is known to exhibit a wetting phase transition, from a…
The wetting properties of solid substrates with customary (i.e., macroscopic) random roughness are considered as a function of the microscopic contact angle of the wetting liquid and its partial pressure in the surrounding gas phase.…
A wetting transition occurs when the contact angle of a liquid drop on a surface changes from a nonzero value to zero. Such a transition has never been observed for water on any solid surface. This paper discusses the value of the…