Related papers: Superconductivity in PbO-type Fe chalcogenides
We investigated the magnetization and crystal structure of FeSe polycrystalline samples with various grain sizes. For the samples with large grains, a large magnetic critical current density Jc was observed. For the samples with small…
There is an ongoing debate about the relative importance of structural change versus doping charge carriers on the mechanism of superconductivity in Fe-based materials. Elucidating this issue is a major challenge since it would require a…
Structure and composition of iron chalcogenides have a delicate relationship with magnetism and superconductivity. In this report we investigate the iron sulfide layered tetragonal phase (t-FeS), and compare with three-dimensional hexagonal…
The Fe-based superconducting KxFe2-ySe2 (0.6 {\leg} x {\leg} 1, 0.2{\leg} y {\leg} 0.4) compounds, unlike the well-known RFe2As2 (R = Ba, Sr, Ca) superconductors, contain complex structural features and notable physical properties, such as…
The electronic structure of FeSe, the simplest iron based superconductor (Fe-SC), conceals a potential of dramatic increase of Tc that realizes under pressure or in a single layer film. This is also the system where nematicity, the…
The issue concerning the nature and the role of microstructural inhomogeneities in iron chalcogenide superconducting crystals of FeTe0.65Se0.35 and their correlation with transport properties of this system was addressed. Presented data…
A new iron-oxychalcogenide (CaO)(FeSe) was obtained which crystallizes in the orthorhombic space group Pnma (No. 62) with a = 5.9180(12) {\AA}, b = 3.8802(8) {\AA}, c = 13.193(3) {\AA}. The unique structure of (CaO)(FeSe) is built up of a…
Less than two years after the discovery of high temperature superconductivity in oxypnictide LaFeAs(O,F) several families of superconductors based on Fe layers (1111, 122, 11, 111) are available. They share several characteristics with…
The high upper critical field characteristic of the recently discovered iron-based superconducting chalcogenides opens the possibility of developing a new type of non-oxide high-field superconducting wires. In this work, we utilize a…
It was observed recently (K. Shigekawa et al, PNAS 116, 2470 (2019)) that while monolayer iron chalcigenide FeSe on SrTiO3 (STO) substrate has a very high critical temperature, its chemical and structural "twin" material FeS=STO has a very…
Since the discovery of superconductivity in the Fe(Te,Se) system, it has been a general consensus that the end member of FeTe is not superconducting. Nonetheless, in recent years, there have been reports of superconducting FeTe films, but…
By realizing in thin films a tensile stress state, superconductivity of 13 K was introduced into FeTe, an non-superconducting parent compound of the iron pnictides and chalcogenides, with transition temperature higher than that of its…
We have discovered superconductivity in the two-layer semiconducting monochalcogenide heterostrutures PbTe/PbS, PbTe/PbSe and PbTe/YbS. By comparing data from two-layer samples with data from single monochalcogenide films we conclude that…
FeSe is a fascinating superconducting material at the frontier of research in condensed matter physics. Here we provide an overview on the current understanding of the electronic structure of FeSe, focusing in particular on its low energy…
In contrast to its bulk crystals, the FeSe film or layer exhibits better superconductivity performance, which attract much interest in its fundamental research as well as potential application. In present work, transition from insulator to…
Once again the condensed matter world has been surprised by the discovery of yet another class of high temperature superconductors. The discovery of iron-pnictide (FeAs) and chalcogenide (FeSe) based superconductors with a $T_c$ of up to 55…
The importance of electron-hole interband interactions is widely acknowledged for iron-pnictide superconductors with high transition temperatures (Tc). However, high-Tc superconductivity without hole carriers has been suggested in FeSe…
The second class of high-temperature superconductors (HTSCs), iron-based pnictides and chalcogenides, necessarily contain Fe$_2$$X_2$ ("$X$" refers to a pnictogen or a chalcogen element) layers, just like the first class of HTSCs which…
FeTe, a non-superconducting parent compound in the iron-chalcogenide family, becomes superconducting after annealing in oxygen. Under the presence of magnetism, spin-orbit coupling, inhomogeneity and lattice distortion, the nature of its…
The recently discovered iron arsenide superconductors, which display superconducting transition temperatures as high as 55 K, appear to share a number of general features with high-Tc cuprates, including proximity to a magnetically ordered…