Related papers: A pump-probe XFEL particle injector for hydrated s…
X-ray Free Electron Lasers (XFELs) can probe chemical and biological reactions as they unfold with unprecedented spatial and temporal resolution. A principal challenge in this pursuit is the delivery of samples to the X-ray interaction…
As shown by Ganan-Calvo and co-workers, a free liquid jet can be compressed in iameter through gas-dynamic forces exerted by a co-flowing gas, obviating the need for a solid nozzle to form a microscopic liquid jet and thereby alleviating…
There is a need for experimental data in conditions representative injection in rocket engines to validate or initiate droplet formation models used in numerical simulations. A new cryogenic vessel was built upon the MASCOTTE test bench to…
X-ray free-electron lasers (XFELs) produce X-ray pulses with high brilliance and short pulse duration. These properties enable structural investigations of biomolecular nanocrystals, and they allow resolving the dynamics of biomolecules…
Illuminating a water solution with a focused continuous wave laser produces a strong local heating of the liquid that leads to the nucleation of bubbles, also known as thermocavitation. During the growth of the bubble, the surrounding…
Underexpanded jets are present in various engineering applications; in recent years, they have gained special attention because of the development of gas-fueled propulsion systems. In these apparatuses, the direct injection of fuels such as…
Spray atomization process involves complex multi-phase phenomena. Abundant literature and validation of spray modelling for industrial applications like fuel injection in internal combustion and turbine jet engines are available. However,…
We propose using a dielectric beveled nozzle for electrospray and electrohydrodynamic jet printing. This nozzle stabilizes the liquid ejection of low-conductivity liquids, considerably reducing the minimum flow rate below which the flow…
We discuss the feasibility of a soft-x-ray distributed feedback laser (DFL) pumped by an x-ray free electron laser (X-FEL). The DFL under consideration is a Mg/SiC bi-layered Bragg reflector pumped by a single X-FEL bunch at 57.4 eV,…
We put forward a co-axial pump(optical)-probe(X-rays) experimental concept and show performance of the optical component. A Bessel beam generator with a central 100 micrometers-diameter hole (on the optical axis) was fabricated using…
We present the first observation, to our knowledge, of lasing from a levitated, dye droplet. The levitated droplets are created by computer controlled pico-liter dispensing into one of the nodes of a standing ultrasonic wave (100 kHz),…
In-air microfluidics became a new method for technical production processes with ultra-high throughput formerly performed in micro channels. Direct Numerical Simulations (DNS) provide a valuable contribution for the fundamental…
We demonstrate through high-fidelity particle-in-cell simulations a simple approach for efficiently generating 20+ GeV electron beams with the necessary charge, energy spread, and emittance for use as the injector for an electron arm of a…
The work show the characterization of a particle laden turbulent jet. For the velocity and mass flux masurements, a PDA system has been used. Either the continuous phase (air) or the dispersed phase (glass spheres) are measured; also, the…
In this work we present, for the first time, a computational fluid dynamics tool for the simulation of the metered discharge in a pressurized metered dose inhaler. The model, based on open-source software, adopts the Volume-Of-Fluid method…
A setup for extreme-ultraviolet time-resolved photoelectron spectroscopy (XUV-TRPES) of liquids is described based on a gas-dynamic flat jet formed by a microfluidic chip device. In comparison to a cylindrical jet that has a typical…
Aerosol injectors applied in single-particle diffractive imaging experiments demonstrated their potential in efficiently delivering nanoparticles with high density. Continuous optimization of injector design is crucial for achieving…
An aerodynamic lens injector was developed specifically for the needs of single-particle diffractive imaging experiments at free-electron lasers. Its design allows for quick changes of injector geometries and focusing properties in order to…
The development of needle-free drug injection systems is of great importance to global healthcare. However, in spite of its great potential and research history over many decades, these systems are not commonly used. One of the main…
We present results from the SPring-8 Angstrom Compact free electron LAser (SACLA) XFEL facility, using a high intensity ($\sim\!10^{20}\,$W/cm$^2$) X-ray pump X-ray probe scheme to observe changes in the ionic structure of silicon induced…