Related papers: Anomalous Structure and Scaling of Ring Polymer Br…
Nanometer-thick supported lms of polymer melts spontaneously form and spread around sessile droplets that are deposited on oxidized silicon wafers. At steady state, the lms become dense and adopt a uniform thickness which is equal to twice…
Particle simulations confined by sharp walls usually develop an oscillatory density profile. For some applications, most notably soft matter liquids, this behavior is often unrealistic and one expects a monotonic density climb instead. To…
The slip phenomena in thin polymer films confined by either flat or periodically corrugated surfaces are investigated by molecular dynamics and continuum simulations. For atomically flat surfaces and weak wall-fluid interactions, the shear…
The conformational statistics of ring polymers in melts or dense solutions is strongly affected by their quenched microscopic topological state. The effect is particularly strong for non-concatenated unknotted rings, which are known to…
We performed molecular dynamics simulations to study equilibrium and flow properties of a liquid in a nano-channel with confining surfaces coated with a layer of grafted semiflexible polymers. The coverage spans a wide range of grafting…
Ring polymers remain a major challenge to our current understanding of polymer dynamics. Experimental results are difficult to interpret because of the uncertainty in the purity and dispersity of the sample. Using both equilibrium and…
We consider the growth of a polymer layer on a flat surface in a good solvent by in-situ polymerization. This is viewed as a modified form of diffusion-limited aggregation without branching. We predict theoretically the formation of a…
The adsorption of a bottle-brush polymer end-grafted with one chain end of its backbone to a flat substrate surface is studied by Monte Carlo simulation of a coarse-grained model, that previously has been characterized in the bulk, assuming…
We study structural properties of a ring polymeric melt confined in a film in comparison to a linear counterpart using molecular dynamics simulations. Local structure orderings of ring and linear polymers in the vicinity of the surface are…
Large scale molecular dynamics simulations on graphic processing units (GPUs) are employed to study the scaling behavior of ring polymers with various topological constraints in melts. Typical sizes of rings containing $3_1$, $5_1$ knots…
Molecular Dynamics (MD) simulations are presented for a coarse-grained bead-spring model of ring polymer brushes under compression. Flexible polymer brushes are always disordered during compression, whereas semiflexible brushes tend to be…
Conformations of a single-component bottle-brush polymer with a fully flexible backbone under poor solvent conditions are studied by molecular-dynamics simulations, using a coarse-grained bead-spring model with side chains of up to N=40…
As an example for the interplay of structure, dynamics, and phase behavior of macromolecular systems, this article focuses on the problem of bottle-brush polymers with either rigid or flexible backbones. On a polymer with chain length…
We study the diffusion of a linear polymer in the presence of permeable membranes without excluded volume interactions, using scaling theory and Monte Carlo simulations. We find that the average time it takes for a chain with polymerization…
Polymers are an effective test-bed for studying topological constraints in condensed matter due to a wide array of synthetically-available chain topologies. When linear and ring polymers are blended together, emergent rheological properties…
The dynamics of ring polymer melts are studied via molecular dynamics simulations of the Kremer-Grest bead-spring model. Rouse mode analysis is performed in comparison with linear polymers by changing the chain length. Rouse-like behavior…
We present a Monte Carlo study of the surface anchoring of a nematic fluid on swollen layers of grafted liquid crystalline chain molecules. The liquid crystalline particles are modeled by soft repulsive ellipsoids, and the chains are made…
The application of a polymer brush in sensing, actuation, self-folding, among others acutely depends on the tuneable bending of a brush-grafted substrate caused by the stress in the brush. However, the stress in a stimuli-responsive brush…
We consider edge effects in grafted polymer layers under compression. For a semi-infinite brush, the penetration depth of edge effects $\xi\propto h_0(h_0/h)^{1/2}$ is larger than the natural height $h_0$ and the actual height $h$. For a…
We present data of Monte Carlo simulations for monodisperse linear polymer chains in dense melts with degrees of polymerization between N=16 and N=512. The aim of this study is to investigate the crossover from Rouse-like dynamics for short…