Related papers: High-speed data transfer with FPGAs and QSFP+ modu…

We develop a custom Bit Error Rate test bench based on Altera's Stratix II GX transceiver signal integrity development kit, demonstrate it on point-to-point serial optical link with data rate up to 5 Gbps, and compare it with commercial…

A large number of data need to be transmitted in high-speed between Field Programmable Gate Array (FPGA) and Advanced RISC Machines 11 micro-controller (ARM11) when we design a small data acquisition (DAQ) system for nuclear experiments.…

We present the design and the test results of a quad-channel optical transceiver module (QTRx) possibly for future particle physics experiments. The transmitters of QTRx, each at 10 Gbps, are based on a Quad-channel VCSEL Diode array Driver…

In the context of the upgrade of the Large Hadron Collider at CERN for high-luminosity operation, the particle detectors have to cope with much higher data rates and therefore need to upgrade their data acquisition systems. This upgrade is…

In high energy physics experiments (HEP), high speed and fault resilient data communication is needed between detectors/sensors and the host PC. Transient faults can occur in the communication hardware due to various external effects like…

Electronic systems for qubit control and measurement serve as a bridge between quantum programming language and quantum information processors. With the rapid development of superconducting quantum circuit (SQC) technology, synchronization…

With present-day detectors in high energy physics one often faces fast analog pulses of a few nanoseconds length which cover large dynamic ranges. In many experiments both amplitude and timing information have to be measured with high…

We describe herein the APElink+ board, a PCIe interconnect adapter featuring the latest advances in wire speed and interface technology plus hardware support for a RDMA programming model and experimental acceleration of GPU networking; this…

The traditional USB 3.0 communication based on FPGA uses an external chip as a USB PHY or a USB controller including a USB PHY. This paper realizes a USB 3.0 controller by using FPGA resources, in which FPGA logic realizes a serial…

This work introduces a highly efficient implementation of the transformer architecture on a Field-Programmable Gate Array (FPGA) by using the \texttt{hls4ml} tool. Given the demonstrated effectiveness of transformer models in addressing a…

Superconducting qubits provide a promising approach to large-scale fault-tolerant quantum computing. However, qubit connectivity on a planar surface is typically restricted to only a few neighboring qubits. Achieving longer-range and more…

As the development of electronic science and technology, electronic data acquisition (DAQ) system is more and more widely applied to nuclear physics experiments. Workstations are often utilized for data storage, data display, data…

This paper presents an RDMA over Ethernet protocol used for data acquisition systems, currently under development at the ESRF. The protocol is implemented on Xilinx Ultrascale + FPGAs thanks to the 100G hard MAC IP. The proposed protocol is…

This paper presents a system consisting of the FPGA IP core, the simple network protocol and the Linux device driver, capable of efficient and reliable data transmission from a low resources FPGA chip to the Linux-based embedded computer…

This paper presents FADE-10G - an integrated solution for modern multichannel measurement systems. Its main aim is a low latency, reliable transmission of measurement data from FPGA-based front-end electronic boards (FEBs) to a…

Electronic systems are becoming more and more ubiquitous as our world digitises. Simultaneously, even basic components are experiencing a wave of improvements with new transistors, memristors, voltage/current references, data converters,…

We are developing a new readout board with a newer generation field-programmable gate array (FPGA) and the 10-gigabit ethernet to improve the performance and usability of the current readout board based on the 1-gigabit Ethernet. In this…

An ultra-high-speed waveform digitizer prototype based on gigabit Ethernet has been developed. The prototype is designed to read out signals of detectors to realize the accurate measurement of various physical quantities for plasma…

We describe the performance of our latest generations of sensitive wide-band high-resolution digital Fast Fourier Transform Spectrometer (FFTS). Their design, optimized for a wide range of radio astronomical applications, is presented.…

The Quad transimpedance and limiting amplifier (QTIA) is a 4-channel array optical receiver ASIC, developed using a 65 nm CMOS process. It is configurable between the bit rate of 2.56 Gbps and 10 Gbps per channel. QTIA offers careful…