Related papers: A Precision Angle Sensor using an Optical Lever in…
A technique to levitate and measure the three-dimensional position of micrometer-sized dielectric spheres with heterodyne detection is presented. The two radial degrees of freedom are measured by interfering light transmitted through the…
We propose a polarization-independent optical isolator that does not use walk-off between the two orthogonal polarizations. The design is based on two Faraday rotators in combination with two half-wave plates in a closed,…
Optomechanical transduction is demonstrated for nanoscale torsional resonators evanescently coupled to optical microdisk whispering gallery mode resonators. The on-chip, integrated devices are measured using a fully fiber-based system,…
We describe the design and performance of a series of fast, precise current sensing noise thermometers. The thermometers have been fabricated with a range of resistances from 1.290 $\Omega$ down to 0.2 m$\mathrm{\Omega}$. This results in…
Knowledge of the intensity and phase profiles of spectral components in a coherent optical field is critical for a wide range of high-precision optical applications. One of these is interferometric gravitational wave detectors, which rely…
We demonstrate phase lock of two >1.6W Titanium:sapphire lasers with a phase noise of -138dBc/Hz at 1MHz from the carrier, using an intra-cavity electro-optic phase modulator. The residual phase variance is 2.5 10^(-8)rad^2 integrated from…
We study the single-photon frequency conversion of a five-level emitter coupled to a Sagnac interferometer. We show that the unity conversion efficiency can be achieved either in resonance or off-resonance case under the ideal condition. In…
Levitated ferromagnetic systems are expected to have significant potential in precision magnetic field sensing by leveraging mechanical isolation to minimize mechanical contact and associated noise. Here, we report the implementation of a…
We present a protocol for using trapped ions to measure rotations via matter-wave Sagnac interferometry. The trap allows the interferometer to enclose a large area in a compact apparatus through repeated round-trips in a Sagnac geometry. We…
Imaging the direct light signal from a faint exoplanet against the overwhelming glare of its host star presents one of the fundamental challenges to modern astronomical instrumentation. Achieving sufficient signal-to-noise for detection by…
High-efficiency optical detectors that can determine the number of photons in a pulse of monochromatic light have applications in a variety of physics studies, including post-selection-based entanglement protocols for linear optics quantum…
A modern Q-band low noise amplifier (LNA) front-end is being fitted to the 10.4 m millimeter-wave telescope at the Raman Research Institute (RRI) to support observations in the 40-50 GHz frequency range. To assess the suitability of the…
The utility of inertial sensors depends on resilience against real-world dynamics and noise. Atom interferometry offers a sensing technology with the advantage of good long-term stability, high sensitivity, and accuracy. High measurement…
A well-balanced detector with high sensitivity and low noise is presented in this paper. The two-stage amplification structure is used to increase electronic gain while keeping an effective bandwidth of about 70 MHz. In order to further…
The ultimate sensitivity of optical measurements is a key element of many recent works. Classically, it is mainly limited by the shot noise limit. However, a measurement setup that incorporates quantum mechanical principles can surpass the…
Presented is a novel way to combine snapshot compressive imaging and lateral shearing interferometry in order to capture the spatio-spectral phase of an ultrashort laser pulse in a single shot. A deep unrolling algorithm is utilised for the…
Inertial sensors based on cold atoms have great potential for navigation, geodesy, or fundamental physics. Similar to the Sagnac effect, their sensitivity increases with the space-time area enclosed by the interferometer. Here, we introduce…
We show that optomechanical pressure sensors with characterized density and thickness can achieve uncertainty as low as 1.1 % via comparison with a secondary pressure standard. The agreement between the secondary standard and our…
We demonstrate the use of an optimized 5 core photonic lantern (PL) to simultaneously measure tip/tilt errors at the telescope focal plane, while also providing the input to an instrument. By replacing a single mode (SM) fiber with the PL…
Interactions between atoms and lasers provide the potential for unprecedented control of quantum states. Fulfilling this potential requires detailed knowledge of frequency noise in optical oscillators with state-of-the-art stability. We…