Related papers: Force-gradient-induced mechanical dissipation of q…
We discuss the application of stress-induced changes in the crystal of a monolithic Nd:YAG laser as a possibility for microforce measurement. In fact, application of an unknown force on the resonator-amplifier-crystal can lead to a several…
We review a new implementation of Kelvin probe force microscopy (KPFM) in which the dissipation signal of frequency modulation atomic force microscopy (FM-AFM) is used for dc bias voltage feedback (D-KPFM). The dissipation arises from an…
A particularly promising pathway to enhance the efficiency of thermoelectric materials lies in the use of resonant states, as suggested by experimentalists and theorists alike. In this paper, we go over the mechanisms used in the literature…
I study dephasing of an underdamped nanomechanical resonator subject to random mass loading of small particles. I present a frequency noise model which describes dephasing due to attachment and detachment of particles at random points and…
We demonstrate a high-Q ($>5 \times 10^{6}$) swept-frequency membrane mechanical resonator achieving octave resonance tuning via an integrated heater and an unprecedented acceleration noise floor below 1 $\mu$g Hz$^{-1/2}$ for frequencies…
Combined effects of the damping and forcing in the underdamped time-delayed Duffing oscillator are considered in this paper. We analyze the generation of a certain damping-induced unpredictability, due to the gradual suppression of…
Resonant sensors based on Micro- and Nano-Electro Mechanical Systems (M/NEMS) are ubiquitous in many sensing applications due to their outstanding performance capabilities, which are directly proportional to the quality factor (Q) of the…
Magnetic force microscopy (MFM) is a well-established technique in scanning probe microscopy that allows for the imaging of magnetic samples with a spatial resolution of tens of nm and stray fields down to the mT range. The spatial…
We propose a method for fast, deterministic resonator reset based on tunable dissipative modes. The dissipator is based on a Josephson junction with relatively low quality factor. When the dissipator is tuned into resonance with a high…
The small mass and high coherence of nanomechanical resonators render them the ultimate force probe, with applications ranging from biosensing and magnetic resonance force microscopy, to quantum optomechanics. A notorious challenge in these…
In crystalline materials, the creation and modulation of dislocations are often associated with plastic deformation and energy dissipation. Here we report a study on the energy dissipation of a trilayer graphene ribbon resonator. The…
Quantum sensors based on atom interferometers are advancing both fundamental physics and practical applications, with higher sensitivity being a key requirement for these investigations. Here, we experimentally demonstrate a sensitivity…
Atomic force microscopy (AFM) using qPlus sensors is a powerful tool for high-resolution analysis in various liquids, including high-viscosity or opaque environments. However, the relatively high displacement sensor noise density (n_{ds}),…
The squeezing spectrum of the resonance fluorescence is studied for a coherently driven four-level atom in the Y-type configuration. It is found that the squeezing properties of the fluorescence radiation are modified significantly when…
The investigations have been conducted on the involved design parameters to analyze the behavior of the microwave displacement sensor output characteristics. To implement this, a dielectric resonator loaded to a reflection mode operated…
We report the eigen-frequency shift induced by an applied voltage on quartz material. The samples are in the form of commercial 32 KHz quartz tuning forks used in watches. Three vibration modes are studied: one prong oscillates, two prongs…
We measure the mechanical thermal noise of soft silicon atomic force microscopy cantilevers. Using an interferometric setup, we have a resolution down to 1E-14 m/rtHz on a wide spectral range (3 Hz to 1E5 Hz). The low frequency behavior…
The gradient of the Casimir force between a Si-SiO${}_2$-graphene substrate and an Au-coated sphere is measured by means of a dynamic atomic force microscope operated in the frequency shift technique. It is shown that the presence of…
Quantum enhanced sensing is a powerful technique in which nonclassical states are used to improve the sensitivity of a measurement. For enhanced mechanical displacement sensing, squeezed states of light have been shown to reduce the photon…
Mechanical dissipation poses an ubiquitous challenge to the performance of nanomechanical devices. Here we analyze the support-induced dissipation of high-stress nanomechanical resonators. We develop a model for this loss mechanism and test…