Related papers: Suppression of Edge Recombination in InAs/InGaAs D…
Recombination through quantum dots (QDs) is a major factor that limits efficiency of QD intermediate-band (IB) solar cells. Our proposal for a new IB solar cell based on type-II GaSb QDs located outside the depletion region of a GaAs…
Metastable defects can decisively influence the diode factor and thus the efficiency of a solar cell. The diode factor is also influenced by the doping level and the recombination mechanisms in the solar cell. Here we quantify how the…
The GaAs/AlGaAs materials system is well suited to multi-bandgap applications such as the multiple quantum well solar cell. GaAs quantum wells are inserted in the undoped AlGaAs active region of a pin structure to extend the absorption…
The observed open circuit voltages in best performing solar cells are explained outside of the recombination paradigm, based on such factors as electrostatic screening, Meyer-Neldel effect, and lateral nonuniformities. The underlying…
Reducing the formation of cracks during growth of GaInP/GaInAs/Ge 3-junction solar cells on Ge|Si virtual substrates has been attempted by thinning the structure, namely the Ge bottom cell and the GaInAs middle cell. The theoretical…
The GaAs/AlGaAs quantum well solar cell (QWSC) shows promise as a novel approach to higher efficiency solar cells but suffers from a poor short circuit current Jsc. We report on efforts to reduce this problem with the use of compositional…
Reducing the thickness of Cu(In,Ga)Se2 solar cells is a key objective in order to reduce production cost and to improve sustainability. The major challenge for sub-micron Cu(In,Ga)Se2 cells is the recombination at the backside. In standard…
We report thin-film InAs/GaAs quantum dot (QD) solar cells with $n-i-p{+}$ deep junction structure and planar back reflector fabricated by epitaxial lift-off (ELO) of full 3-inch wafers. External quantum efficiency measurements demonstrate…
In this paper, we have designed and investigated the performance of radial GaAs/AlGaAs pin junction nanocone array solar cells by performing coupled optoelectronic simulations to obtain the most optimal design configuration based on its…
A high theoretical efficiency of 47.2% was achieved by a novel combination of In0.51Ga0.49P, GaAs, In0.24Ga0.76As and In0.19Ga0.81Sb subcell layers in a simulated quadruple junction solar cell under 1 sun concentration. The electronic…
The carrier recombination dynamics of InGaP/InGaAsP quantum wells are reported for the first time. By studying the photoluminescence (PL) and time-resolved PL decay of InGaP/InGaAsP multiple-quantum-well(MQW) heterostructure samples, it is…
A high photon to electricity conversion efficiency of 47.2082% was achieved by a novel combination of In0.51Ga0.49P, GaAs, In0.24Ga0.76As and In0.19Ga0.81Sb subcell layers in a quadruple junction solar cell design. The electronic bandgap of…
We used AlGaSb/AlGaAs material system for a theoretical study of photovoltaic performance of the proposed GaAs-based solar cell in which the type-II quantum dot (QDs) absorber is spatially separated from the depletion region. Due to…
The efficiency of GaAs nanowire solar cells can be significantly improved without any new processing steps or material requirements. We report coupled optoelectronic simulations of a GaAs nanowire (NW) solar cell with vertical p-i-n…
The purpose of this work is to look for a practical structure for application of quantum dots (QD) in solar cells in order to enhance sub-band gap photon absorption. We focuse on a stack of strain-compensated GaSb/GaAs type-II QDs. We…
The growth of heavily doped tunnel junctions in inverted metamorphic multijunction solar cells induces a strong diffusion of Zn via a point-defects-assisted mechanism. The redistribution of Zn can compensate the n-type doping in the emitter…
In this study, we designed and optimized the performance of pin junction GaAs/AlGaAs heterojunction nanowire solar cell arrays. It is done by performing coupled optoelectronic simulations to find the optimal doping for the GaAs core and…
The spectral response of quantum well solar cells (QWSCs) is well understood. We describe work on QWSC dark current theory which combined with SR theory yields a system efficiency. A methodology published for single quantum well (SQW)…
Solar cells manufactured on top of Ge substrates suffer from inherent drawbacks that hinder or limit their potential. The most deleterious ones are heavy weight, high bulk recombination, lack of photon confinement and an increase of the…
Recombination losses contribute to reduce $J_{SC}$, $V_{OC}$ and the fill factor of organic solar cells. Recent advances in non-fullerene organic photovoltaics have shown, nonetheless, that efficient charge generation can occur under small…