Related papers: Compact USB measurement and analysis system for re…
The plasma panel sensor (PPS) is an inherently digital, high gain, novel variant of micropattern gas detectors inspired by many operational and fabrication principles common to plasma display panels (PDPs). The PPS is comprised of a dense…
Advances in nanomechanics within recent years have demonstrated an always expanding range of devices, from top-down structures to appealing bottom-up MoS$_2$ and graphene membranes, used for both sensing and component-oriented applications.…
We present megas, a new software tool that improves the simulation of the Micromegas gas detectors. Our tool offers the possibility to configure multiple arrangements with one or more layers of MM detectors. A series of simple commands can…
By recognizing the tremendous flexibility of the emerging fluid antenna system (FAS), which allows dynamic reconfigurability of the location of the antenna within a given space, this paper investigates the performance of a single-antenna…
We consider the fluctuations in atom number that occur within finite-sized measurement cells in a trapped Bose-Einstein condensate (BEC). This approximates the fluctuation measurements made in current experiments with finite resolution in…
This work is about a slow-fast data assimilation system under non-Gaussian noisy fluctuations. Firstly, we show the existence of a random invariant manifold for a stochastic dynamical system with non-Gaussian noise and two-time scales.…
Quantum technology is approaching a level of maturity, recently demonstrated in space-borne experiments and in-field measurements, which would allow for adoption by non-specialist users. Parallel advancements made in microprocessor-based…
This paper proposes a hardware-software co-design approach to efficiently optimize beamforming and port selection in fluid antenna systems (FASs). To begin with, a fluid-antenna (FA)-enabled downlink multi-cell multiple-input…
The measurement of thermal fluctuations provides information about the microscopic state of a thermodynamic system and can be used in order to extract work from a single heat bath in a suitable cyclic process. We present a minimal framework…
Observing, understanding, and mitigating the effects of failure in embedded systems is essential for building dependable control systems. We develop a software-based monitoring methodology to further this goal. This methodology can be…
The smaller the system, typically - the higher is the impact of fluctuations. In narrow superconducting wires sufficiently close to the critical temperature Tc thermal fluctuations are responsible for the experimentally observable finite…
Voltage fluctuations are one of the most common low-frequency disturbances of power quality. Diagnostics of these disturbances are a complex process because voltage fluctuations affect different loads in different ways. Therefore, there is…
Microwave reflectometry is a non-intrusive plasma diagnostic tool which is widely applied in many fusion devices. In 2014, the microwave reflectometry on Experimental Advanced Superconducting Tokamak (EAST) had been upgraded to measure…
In the last few decades, several wearable devices have been designed to monitor respiration rate in an effort to capture pulmonary signals with higher accuracy and reduce patients' discomfort during use. In this article, we present the…
We have fabricated Transition Edge Sensors (TESs) whose thermal characteristics are completely characterised by few-mode ballistic phonon exchange with the heat bath. These TESs have extremely small amorphous SiNx support legs: 0.2 um…
Ultrasound sensors have wide applications across science and technology. However, improved sensitivity is required for both miniaturisation and increased spatial resolution. Here, we introduce cavity optomechanical ultrasound sensing, where…
An alternative approach to ultrasound computed tomography (USCT) for medical imaging is proposed, with the intent to (i) shorten acquisition time for devices with a large number of emitters, (ii) eliminate the calibration step, and (iii)…
Power consumption is a major concern in data centers and HPC applications, with GPUs typically accounting for more than half of system power usage. While accurate power measurement tools are crucial for optimizing the energy efficiency of…
The fluctuations of turbulence intensity in a pipe flow around the critical Reynolds number is difficult to study but important because they are related to turbulent-laminar transitions. We here propose a rare-event sampling method to study…
This letter describes the manufacturing and experimental characterization of novel stretchable strain sensors for continuum robots. The overarching goal of this research is to provide a new solution for the shape sensing of these devices.…