Related papers: Silicon Detector Arrays with Absolute Quantum Effi…
A new method to tag the barium daughter in the double beta decay of $^{136}$Xe is reported. Using the technique of single molecule fluorescent imaging (SMFI), individual barium dication (Ba$^{++}$) resolution at a transparent scanning…
We present an alternative approach to the fabrication of highly efficient superconducting nanowire single-photon detectors (SNSPDs) based on tungsten silicide. Using well-established technologies for the deposition of dielectric mirrors and…
We have observed strong photoluminescence from a single CdSe quantum dot embedded in a ZnSe nanowire. Exciton, biexciton and charged exciton lines have been identified unambiguously using photon correlation spectroscopy. This technique has…
A proof of concept detector is presented for scintillation light detection in liquid argon using Silicon Photo-Multipliers. The aim of the work is to build an anti-Compton veto for germanium detectors operated directly in liquid argon like…
Optical metasurfaces have revolutionized analog computing and image processing at sub-wavelength scales with faster speed and lower power consumption. They typically involve spatial differentiation with engineered angular dispersion.…
All optical detectors to date annihilate photons upon detection, thus excluding repeated measurements. Here, we demonstrate a robust photon detection scheme which does not rely on absorption. Instead, an incoming photon is reflected off an…
The detective quantum efficiency (DQE) and normalised noise power spectrum (NNPS) of the Timepix4 hybrid pixel detector in event-driven mode in TEM have been measured at 100 kV and 200 kV. In a raw data readout mode, the zero-frequency DQE…
We show how the same set-up and procedure, exploiting spatially multi-mode quantum correlations, allows the absolute calibration of a EMCCD camera from the analog regime down to the single photon counting level, just by adjusting the…
We have integrated a commercial avalanche photodiode (APD) and the circuitry needed to operate it as a single-photon detector (SPD) onto a single PC-board. At temperatures accessible with Peltier coolers (~200-240K), the PCB-SPD achieves…
The growing interest in quantum information has enabled the manipulation and readout of microwave photon states with high fidelities. The presently available microwave photon counters, based on superconducting circuits, are limited to…
At the core of an ideal single photon detector is an active material that ideally absorbs and converts photons to discriminable electronic signals. A large active material volume favours high-efficiency absorption, but often at the expense…
In developing photovoltaic devices with high efficiencies, quantitative determination of the carrier loss is crucial. In conventional solar-cell characterization techniques, however, photocurrent reduction originating from parasitic light…
This work presents methods of controlling the density of self-assembled CdTe quantum dots (QDs) grown by molecular beam epitaxy. Two approaches are discussed: increasing the deposition temperature of CdTe and the reduction of CdTe layer…
In quantum communication systems, the precise estimation of the detector's response to the incoming light is necessary to avoid security breaches. The typical working regime uses a free-running single-photon avalanche diode in combination…
A silicon light source at communication wavelength is the bottleneck for developing monolithically integrated silicon photonics. Doping silicon with erbium ions was believed to be one of the most promising approaches but suffers from the…
We discuss a novel approach to the problem of creating a photon number resolving detector using the giant Kerr nonlinearities available in electromagnetically induced transparency. Our scheme can implement a photon number quantum…
Most optoelectronic devices operate at high photocarrier densities, where all semiconductors suffer from enhanced nonradiative recombination. Nonradiative processes proportionately reduce photoluminescence (PL) quantum yield (QY), a…
The quantum efficiencies (QE) of photocathodes consisting of bulk Nb substrates coated with thin films of Cs2Te are reported. Using the standard recipe for Cs2Te deposition developed for Mo substrates (220 {\AA} Te thickness), a QE ~11% -…
We report first results of laboratory tests of Si:As blocked-impurity-band (BIB) mid-infrared (4 to 28 um) detectors developed by IMEC. These prototypes feature 88 pixels hybridized on an integrated cryogenic readout electronics (CRE). They…
The improvement of light absorption in Si/BeSe$_{0.41}$Te$_{0.59}$ heterostructures for solar cell applications is studied theoretically. First, using simple approaches we found that light absorption could be improved in a single…