Related papers: Signal coupling and signal integrity in multi-stri…
Cell-free widely distributed massive multiple-input multiple-output (MIMO) systems utilize radio units spread out over a large geographical area. The radio signal of a user equipment (UE) is coherently detected by a subset of radio units…
We propose and analyse a model predictive control (MPC) strategy tailored for networks of underwater agents tasked with maintaining formation while following a shared path and using acoustic communication channels. The strategy accommodates…
As part of the Compact Muon Solenoid experiment Phase-II upgrade program, new Resistive Plate Chambers will be installed in the forward region. High background conditions are expected in this region during the high-luminosity phase of the…
We experimentally demonstrate a broadband, fabrication tolerant, CMOS compatible compact silicon waveguide taper (34.2 um) in silicon-on-insulator wire waveguides. The taper works on multi-mode interference along the length of the taper. A…
Metasurface anomalous reflectors can enhance future wireless communication systems due to their ability to redirect electromagnetic waves and establish metasurface-assisted communication links. However, metasurface reflectors typically…
We exploit multi-path fading propagation to improve both the signal-to-interference-plus-noise-ratio and the stability of wireless communications within electromagnetic environments that support rich multipath propagation. Quasi-passive…
Phase synchronization among distributed transmission reception points (TRPs) is a prerequisite for enabling coherent joint transmission and high-precision sensing in millimeter wave (mmWave) cell-free massive multiple-input and…
We consider a cellular massive MIMO system where swarms of wireless repeaters are deployed to improve coverage. These repeaters are full-duplex relays with small form factors that receive and instantaneously retransmit signals. They can be…
This letter proposes a novel anti-interference communication method leveraging computational antennas, utilizing time averaging and 1-bit reconfigurable intelligent surfaces (RIS) to achieve robust signal modulation with minimal hardware…
Backscatter communication (BSC) technology can enable ubiquitous deployment of low-cost sustainable wireless devices. In this work we investigate the efficacy of a full-duplex multiple-input-multiple-output (MIMO) reader for enhancing the…
MicroPattern Gaseous Detectors (MPGD) made of resistive strips have raised as a promising technology for the protection against spark processes having place in the gaseous chamber. The reproduction of the signals and its propagation through…
Reconfigurable intelligent surfaces (RISs) have gained significant attention in recent years due to their ability to control the reflection of radio-frequency signals and reshape the wireless propagation environment. Unlike traditional…
The intensity distribution of electromagnetic polar waves in a chain of near-resonant weakly-coupled scatterers is investigated theoretically and supported by a numerical analysis. Critical scaling behavior is discovered for part of the…
Ubiquitous multicore processors nowadays rely on an integrated packet-switched network for cores to exchange and share data. The performance of these intra-chip networks is a key determinant of the processor speed and, at high core counts,…
This paper focuses on the parameterization of the multipath propagation model (MPM) for indoor broadband power line communications (PLC), which up to now has been established in an heuristic way. The MPM model was initially proposed in the…
A novel Rateless-coding-assisted Multi-Packet Relaying (RMPR) protocol is proposed for large-size data spreading in mobile wireless networks. With this lightweight and robust protocol, the packet redundancy is reduced by a factor of $\sqrt…
This paper focuses on robust transceiver design for throughput enhancement on the interference channel (IC), under imperfect channel state information (CSI). In this paper, two algorithms are proposed to improve the throughput of the…
The application of distributed model predictive controllers (DMPC) for multi-agent systems (MASs) necessitates communication between agents, yet the consequence of communication data rates is typically overlooked. This work focuses on…
In distributed model predictive control (MPC), the control input at each sampling time is computed by solving a large-scale optimal control problem (OCP) over a finite horizon using distributed algorithms. Typically, such algorithms require…
Performances of several single gap (gas gap 2 mm) prototype Resistive Plate Chambers (RPC) made of high resistive ({\rho} \sim 1010 - 1012 {\Omega} cm) bakelite, commercially available in India have been studied in recent times. To make the…