Related papers: Modelling to study its non-linear effects on Commu…
In this paper, the feasibility of adopting an intelligent reflective surface (IRS) in a cell-free wireless communication system is studied. The received signal-to-noise ratio (SNR) for this IRS-enabled cell-free set-up is optimized by…
In this paper, a comprehensive performance analysis of a distributed intelligent reflective surfaces (IRSs)-aided communication system is presented. First, the optimal signal-to-noise ratio (SNR), which is attainable through the direct and…
In this paper, for the first time real-world channel measurements are used to analyse the performance of spatial modulation (SM), where a full analysis of the average bit error rate performance (ABER) of SM using measured urban correlated…
This paper studies the performance of single-input multiple-output (SIMO) systems under receive antenna selection (RAS) and BPSK/QPSK modulations. At the receiver, a subset of branches are selected and combined using maximal-ratio combining…
The performance of multiple-input multiple-output wireless systems is investigated in the presence of statistical queueing constraints. Queuing constraints are imposed as limitations on buffer violation probabilities. The performance under…
Signal to Noise Ratio (SNR) is an important index for wireless communications. In CDMA systems, spreading sequences are utilized. This series of papers show the method to derive spreading sequences as the solutions of the non-linear…
Compensating for nonlinear effects using digital signal processing (DSP) is complex and computationally expensive in long-haul optical communication systems due to intractable interactions between Kerr nonlinearity, chromatic dispersion…
In this paper, we derive a performance comparison between two training-based schemes for Multiple-Input Multiple-Output (MIMO) systems. The two schemes are thetime-division multiplexing scheme and the recently proposed data-dependent…
Selection combining (SC) at the destination for differential amplify-and-forward (AF) relaying is attractive as it does not require channel state information as compared to the semi maximum-ratio-combining (semi-MRC) while delivering close…
The quality of wireless communication will directly affect the performance of federated learning (FL), so this paper analyze the influence of wireless communication on FL through symbol error rate (SER). In FL system, non-orthogonal…
Achievable information rates (AIRs) of wideband optical communication systems using ~40 nm (~5 THz) EDFA and ~100 nm (~12.5 THz) distributed Raman amplification are estimated based on a first-order perturbation analysis. The AIRs of each…
This work analyzes the performance of a downlink multi-user multiple-input multiple-output (MU-MIMO) non-orthogonal multiple access (NOMA) communications system. To reduce hardware complexity and exploit antenna diversity, we consider a…
This paper investigates the average symbol error rate (ASER) performance of a dual-hop hybrid relaying system relying on both radio frequency (RF) and free space optical (FSO) links. Specifically, the RF link is used for supporting mobile…
In this paper, we analyze the bit-error-rate (BER) performance of wireless sensor networks. A wireless sensor node with a single transmitter antenna and multiple receiver antennas is considered here. We consider M (M greater or equal ro 1)…
Machine learning (ML) has shown great promise in optimizing various aspects of the physical layer processing in wireless communication systems. In this paper, we use ML to learn jointly the transmit waveform and the frequency-domain…
Signal clipping is a classic technique for reducing peak-to-average power ratio (PAPR) in orthogonal frequency division multiplexing (OFDM) systems. It has been widely applied in consumer electronic devices owing to its low complexity and…
We present a formalism for modelling parametric amplification by resonators subject to rate-limited nonlinearity of mixed reactive/dissipative character, with particular relevance to superconducting devices. The non-linearity is assumed to…
In this paper, we present asymptotic high dimensional analysis of the regularised zero-forcing (RZF) receiver in terms of its mean squared error (MSE) and bit error rate (BER) when used for the recovery of binary phase shift keying (BPSK)…
Cooperative beamforming (CB) has been proposed as a special case of coordinated multi-point techniques in wireless communications. In wireless sensor networks, CB can enable low power communication by allowing a collection of sensor nodes…
Signal to Noise Ratio (SNR) is an important index for wireless communications. There are many methods for increasing SNR. In CDMA systems, spreading sequences are used. We consider the frequency-selective wide-sense-stationary…