Related papers: Results from electrostatic calibrations for measur…
We have performed precision electrostatic calibrations in the sphere-plane geometry and observed anomalous behavior. Namely, the scaling exponent of the electrostatic signal with distance was found to be smaller than expected on the basis…
We report on a proposal aimed at measuring the Casimir force in a cylinder-plane configuration. The Casimir force is evaluated including corrections due to finite parallelism, conductivity, and temperature. The range of validity of the…
We report on measurements of forces acting between two conducting surfaces in a spherical-plane configuration in the 35 nm-1 micrometer separation range. The measurements are obtained by performing electrostatic calibrations followed by a…
A number of experimental measurements of the Casimir force have observed a logarithmic distance variation of the voltage that minimizes electrostatic force between the plates in a sphere-plane geometry. We show that this variation can be…
Recently W. J. Kim, M. Brown-Hayes, D. A. R. Dalvit, J. H. Brownell, and R. Onofrio [Phys. Rev. A, v.78, 036102(R) (2008)] performed electrostatic calibrations for a plane plate above a centimeter-size spherical lens at separations down to…
In a recent paper (Phys.Rev.A78, 020101(R) (2008)), Kim at al. have reported a large anomaly in the scaling law of the electrostatic interaction between a sphere and a plate, which was observed during the calibration of their Casimir force…
We consider the Casimir interaction between a cylinder and a hollow cylinder, both conducting, with parallel axis and slightly different radii. The Casimir force, which vanishes in the coaxial situation, is evaluated for both small and…
We compare the results of capacitance measurements in the lens-plane and sphere-plane configurations with theoretical predictions from various models of a spherical surface. It is shown that capacitance measurements are incapable of…
The existence of a monotonic distance dependent contact potential between two plates in a Casimir experiment leads to an additional electrostatic force that is significantly different from the case of a constant potential. Such a varying…
Several new experiments have extended studies of the Casimir force into new and interesting regimes. This recent work will be briefly reviewed. With this recent progress, new issues with background electrostatic effects have been uncovered.…
We have performed numerical simulations to evaluate the effect on the capacitance of finite size boundaries realistically present in the parallel plane, sphere-plane, and cylinder-plane geometries. The potential impact of edge effects in…
Patch potentials arising from the polycrystalline structure of material samples may contribute significantly to measured signals in Casimir force experiments. Most of these experiments are performed in the sphere-plane geometry, yet, up to…
We investigate the possibility of measuring the thermal Casimir force and its gradient in the configuration of a plate and a microfabricated cylinder attached to a micromachined oscillator. The Lifshitz-type formulas in this configuration…
We numerically evaluate the Casimir interaction energy for configurations involving two perfectly conducting eccentric cylinders and a cylinder in front of a plane. We consider in detail several special cases. For quasi-concentric…
In a recent Comment, Decca et al. [Phys. Rev. A 79, 026101 (2009); arXiv:0809.3576] discussed the origin of the anomalies recently reported by us in Phys. Rev. A 78, 036102(R) (2008); arXiv:0812.0028 . Here we restate our view, corroborated…
Casimir force searches provide among the most sensitive laboratory probes of new short range interactions. Existing constraints rely almost exclusively on a single geometry. We show that Casimir geometry constitutes an independent…
We report on measurements of the Casimir force in a sphere-plane geometry using a cryogenic force microscope to move the force probe in situ over different materials. We show how the electrostatic environment of the interacting surfaces…
We present an overview of the validity of the Proximity Force Approximation (PFA) in the calculation of Casimir forces between perfect conductors for different geometries, with particular emphasis for the configuration of a cylinder in…
We investigate the Casimir force between a microfabricated elliptic cylinder (cylindrical lens) and a plate made of real materials. After a brief discussion of the fabrication procedure, which typically results in elliptic rather than…
An exact calculation of electromagnetic scattering from a perfectly conducting parabolic cylinder is employed to compute Casimir forces in several configurations. These include interactions between a parabolic cylinder and a plane, two…