Related papers: Towards Fully Optimized BICM Transceivers
Existing studies about ambient backscatter communication mostly assume flat-fading channels. However, frequency-selective channels widely exist in many practical scenarios. Therefore, this paper investigates ambient backscatter…
In this paper, diversity analysis of bit-interleaved coded multiple beamforming (BICMB) is extended to the case of general spatial interleavers, removing a condition on their previously known design criteria and quantifying the resulting…
For high speed ultra-wideband (UWB) communication systems, the multipath interference exhibits a primary obstacle to improve transmission performance. In order to enhance the signal to interference plus noise ratio (SINR) in the receiver, a…
We consider a block fading additive white Gaussian noise (AWGN) channel with perfect channel state information (CSI) at the transmitter and the receiver. First, for a given codeword length and non-vanishing average probability of error, we…
In this paper, an iterative interference cancellation (IIC) based BICM-ID receiver is designed to cancel the intrinsic interference in FBMC-QAM systems. The proposed receiver consist of an inner decoder, which combines iterative…
Bipolar modulation increases the achievable information rate of communication links with direct-detection receivers. This paper optimizes bipolar transmission with a modulator bias offset for short-reach fiber links. A neural network…
Classical beamforming techniques rely on highly linear transmitters and receivers to allow phase-coherent combining at the transmitter and receiver. The transmitter uses beamforming to steer signal power towards the receiver, and the…
An analysis of the diversity gain for bit-interleaved coded multiple beamforming (BICMB) method in millimeter-wave (mm-Wave) massive multiple-input multiple-output (MIMO) systems is carried out for both the single-user and multi-user…
The idea of media-based modulation (MBM) is to embed information in the channel states via intentional perturbations of the transmission media. This article covers a broad range of topics regarding MBM, expanding on its benefits and…
Inspired by compressive sensing principles, we propose novel error control coding techniques for communication systems. The information bits are encoded in the support and the non-zero entries of a sparse signal. By selecting a dictionary…
The scalability of most transition-edge sensor arrays is limited by the multiplexing technology which combines their signals over a reduced number of wires and amplifiers. In this Letter, we present and demonstrate a multiplexer design…
A decode and forward protocol based Trellis Coded Modulation (TCM) scheme for the half-duplex relay channel, in a Rayleigh fading environment, is presented. The proposed scheme can achieve any spectral efficiency greater than or equal to…
Wireless communication is the most effective communication to convey audio or video information among the population. It enables the masses to connect throughout the world. Wireless technologies improve the lifestyle of individuals in rural…
We propose a low-complexity receiver structure for the recently introduced Affine Filter Bank Modulation (AFBM) scheme, which is a novel waveform designed for integrated sensing and communications (ISAC) systems operating in…
We study communication systems over band-limited Additive White Gaussian Noise (AWGN) channels in which the transmitter output is constrained to be symmetric binary (bi-polar). In this work we improve the original Ozarov-Wyner-Ziv (OWZ)…
In this paper, the problem of designing a linear precoder for Multiple-Input Multiple-Output (MIMO) systems in conjunction with Quadrature Amplitude Modulation (QAM) is addressed. First, a novel and efficient methodology to evaluate the…
The recently developed affine frequency division multiplexing (AFDM) can achieve full diversity in doubly selective channels, providing a comprehensive sparse representation of the delay-Doppler domain channel. Thus, accurate channel…
Multiple-input multiple-output orthogonal frequency division multiplexing with index modulation (MIMO-OFDM-IM) is a novel multicarrier transmission technique which has been proposed recently as an alternative to classical MIMO-OFDM. In this…
Time-Division Multiplexing is the readout architecture of choice for many ground and space experiments, as it is a very mature technology with proven outstanding low-frequency noise stability, which represents a central challenge in…
In this paper, we newly present a closed-form bit-error rate (BER) expression for an $M$-ary pulse-amplitude modulation ($M$-PAM) over additive white Gaussian noise (AWGN) channels by analytically characterizing the bit decision regions and…