Related papers: Towards Fully Optimized BICM Transceivers
Generalized spatial modulation-aided affine frequency division multiplexing (GSM-AFDM) is conceived for reliable multiple-input multiple-output (MIMO) communications over doubly selective channels. \textcolor{black}{We commence by proposing…
We propose a factor-graph-based approach to joint channel-estimation-and-decoding (JCED) of bit- interleaved coded orthogonal frequency division multiplexing (BICM-OFDM). In contrast to existing designs, ours is capable of exploiting not…
Integrated sensing and communication (ISAC) emerges as a promising technology for B5G/6G, particularly in the millimeter-wave (mmWave) band. However, the widely utilized hybrid architecture in mmWave systems compromises multiplexing gain…
The optimal bit-wise demodulator for M-ary pulse amplitude modulation (PAM) over the additive white Gaussian noise channel is analyzed in terms of uncoded bit-error rate (BER). New closed-form BER expressions for 4-PAM with any labeling are…
A channel with continuous phase modulation and 1-bit ADC with oversampling is considered. Due to oversampling, higher-order modulations yield a higher achievable rate and this work presents a method to approach this with sophisticated…
The minimum average signal-to-noise ratio (SNR) per bit required for error-free transmission over a fading channel is derived, and is shown to be equal to that of the additive white Gaussian noise (AWGN) channel, which is $-1.6$ dB.…
This paper presents enhanced receiver metrics for joint estimation-detection in short blocklength transmissions, addressing scenarios with unknown channel state information and low or sparse training resource density. We show that it is…
This paper considers the joint transceiver design in a wireless sensor network where multiple sensors observe the same physical event and transmit their contaminated observations to a fusion center, with all nodes equipped with multiple…
Channel uncertainty and co-channel interference are two major challenges in the design of wireless systems such as future generation cellular networks. This paper studies receiver design for a wireless channel model with both time-varying…
Ambient backscatter communication (AmBC) enables radio-frequency (RF) powered backscatter devices (BDs) (e.g., sensors, tags) to modulate their information bits over ambient RF carriers in an over-the-air manner. This technology also called…
Channel memory and inter-symbol interference (ISI) are harmful factors in diffusion-based molecular communication (DBMC) between bionanosensors. To tackle these problems, this paper proposes a lightweight ISI-mitigating coding scheme to…
The idea of Media-based Modulation (MBM) is to embed information in the variations of the transmission media (channel states). Using an RF closure with $w$ RF walls, MBM creates a set of $2^w$ select-able states for the end-to-end channel.…
The potential of deploying large-scale antenna arrays in future wireless systems has stimulated extensive research on hybrid transceiver designs aiming to approximate the optimal fully-digital schemes with much reduced hardware cost and…
The problem of modulation classification for a multiple-antenna (MIMO) system employing orthogonal frequency division multiplexing (OFDM) is investigated under the assumption of unknown frequency-selective fading channels and…
Orthogonal Frequency Division Multiplexing (OFDM) has gained a lot of popularity over the years. Due to its popularity, OFDM has been adopted as a standard in cellular technology and Wireless Local Area Network (WLAN) communication systems.…
We propose deep learning based coded waveform design for integrated sensing and communication (ISAC) with orthogonal frequency-division multiplexing (OFDM). Our goal is to design a coded waveform capable of delivering accurate target…
In this work, we propose a new multiple-input multiple-output (MIMO) concept, which is called coordinate interleaved orthogonal design with media-based modulation (CIOD-MBM). The proposed two novel CIOD-MBM schemes provide improved data…
Multiple beamforming is realized by singular value decomposition of the channel matrix which is assumed to be known to both the transmitter and the receiver. Bit-Interleaved Coded Multiple Beamforming (BICMB) can achieve full diversity as…
Integrated Sensing and Communication (ISAC) emerges as a promising technology for B5G/6G, particularly in the millimeter-wave (mmWave) band. However, the widespread adoption of hybrid architecture in mmWave systems compromises multiplexing…
This paper investigates symbol detection for single-carrier communication systems operating in the presence of additive interference with Nakagami-m statistics. Such interference departs from the assumptions underlying conventional…