Related papers: Optoelectronic cooling of mechanical modes in a se…
Optomechanical systems show tremendous promise for high sensitivity sensing of forces and modification of mechanical properties via light. For example, similar to neutral atoms and trapped ions, laser cooling of mechanical motion by…
Optomechanical cooling of multiple degenerate mechanical modes is prevented by the mechanical dark mode due to destructive interference. Here we report the first experimental demonstration of simultaneous cooling of two near-degenerate…
Optomechanical cooling of levitated dielectric particles represents a promising new approach in the quest to cool small mechanical resonators towards their quantum ground state. We investigate two-mode cooling of levitated nanospheres in a…
We analyze the performance of optomechanical cooling of a mechanical resonator in the presence of a degenerate optical parametric amplifier within the optomechanical cavity, which squeezes the cavity light. We demonstrate that this allows…
We present a novel method for opto-mechanical cooling of sub-wavelength sized nanomechanical resonators. Our scheme uses a high finesse Fabry-Perot cavity of small mode volume, within which the nanoresonator is acting as a…
Sympathetic cooling with ultracold atoms and atomic ions enables ultralow temperatures in systems where direct laser or evaporative cooling is not possible. It has so far been limited to the cooling of other microscopic particles, with…
We propose and analyze theoretically a cavity optomechanical analog of a heat pump that uses a polariton fluid to cool mechanical modes coupled to a single pre-cooled phonon mode via external modulation of the substrate of the mechanical…
We describe a cryogenic cavity-optomechanical system that combines Si3N4 membranes with a mechanically-rigid Fabry-Perot cavity. The extremely high quality-factor frequency products of the membranes allow us to cool a MHz mechanical mode to…
We present a highly reflective, sub-wavelength-thick membrane resonator featuring high mechanical quality factor and discuss its applicability for cavity optomechanics. The $88.5~\text{nm}$ thin stoichiometric silicon-nitride membrane,…
We simultaneously cool $\gtrsim$100 mechanical modes of a membrane with a photothermally modified optical cavity driven by a single blue-detuned laser. In contrast to radiation pressure and bolometric forces applied directly to the…
Optical measurements of a nanoscale silicon optomechanical crystal cavity with a mechanical resonance frequency of 3.6GHz are performed at sub-kelvin temperatures. We infer optical-absorption-induced heating and damping of the mechanical…
Optomechanical cavities in the well-resolved-sideband regime are ideally suited for the study of a myriad of quantum phenomena with mechanical systems, including backaction-evading measurements, mechanical squeezing, and generation of…
We investigate laser cooling of an ensemble of atoms in an optical cavity. We demonstrate that when atomic dipoles are sychronized in the regime of steady-state superradiance, the motion of the atoms may be subject to a giant frictional…
A patterned Si nanobeam is formed which supports co-localized acoustic and optical resonances that are coupled via radiation pressure. Starting from a bath temperature of T=20K, the 3.68GHz nanomechanical mode is cooled into its quantum…
We present an experimental study of dynamical back-action cooling of the fundamental vibrational mode of a thin semitransparent membrane placed within a high-finesse optical cavity. We study how the radiation pressure interaction modifies…
Optomechanics is a prime example of light matter interaction, where photons directly couple to phonons, allowing to precisely control and measure the state of a mechanical object. This makes it a very appealing platform for testing…
Thermal noise is a major obstacle to observing quantum behavior in macroscopic systems. To mitigate its effect, quantum optomechanical experiments are typically performed in a cryogenic environment. However, this condition represents a…
Quantum manipulation of coupled mechanical resonators has become an important research topic in optomechanics because these systems can be used to study the quantum coherence effects involving multiple mechanical modes. A prerequisite for…
We predict ground state cooling of a micro-mechanical oscillator, i.e. a vibrating end-mirror of an optical cavity, by resonant coupling of mirror vibrations to a narrow internal optical transition of an ensemble of two level systems. The…
The radiation pressure of light can act to damp and cool the vibrational motion of a mechanical resonator. In understanding the quantum limits of this cooling, one must consider the effect of shot noise fluctuations on the final thermal…