Related papers: On chip, high-sensitivity thermal sensor based on …
Recent advancements in soft robots, human-machine interfaces, and wearable electronics have led to an increased demand for high-performance soft tactile sensors. Tomographic tactile sensor based on resistive coupling is a novel contact…
We are developing an imaging polarimeter by combining a fine-pixel CMOS image sensor with a coded aperture mask as part of the cipher project, aiming to achieve X-ray polarimetry in the energy range of…
A sensor for thermal and thermodynamic measurements of small magnetic systems have been designed and built. It is based on a 5μm-thick suspended polymer membrane, which has a very low heat capacity (≈ 10-6 J/K at nitrogen…
The utilization and engineering of thermo-optic effects have found broad applications in integrated photonic devices, facilitating efficient light manipulation to achieve various functionalities. Here, we perform both an experimental…
We report the first observation of a superconducting transition in a 3D printed, metallised-plastic device. A cylindrical cavity is 3D printed from a photosensitive polymer resin and then a 20 $\mu$m layer of tin deposited. A resonant TE…
Time-domain thermoreflectance (TDTR) is a powerful technique for characterizing the thermal properties of layered materials. However, its effectiveness at modulation frequencies below 0.1 MHz is hindered by pulse accumulation effects,…
Using a new brand of commercially available carbon resistor we built a cryogenic thermometer with an extremely good thermal contact to its thermal environment. Because of its superior thermal contact the thermometer is insensitive to low…
Optical-based nanothermometry represents a transformative approach for precise temperature measurements at the nanoscale, which finds versatile applications across biology, medicine, and electronics. The assembly of ratiometric fluorescent…
The Transition Edge Sensor is extremely sensitive to the change of temperature, combined with the high-Z metal of a certain thickness, it can realize the high energy resolution measurement of particles such as X-rays. X-rays with energies…
Synchrotron X-ray reflectivity (XRR) confirms the formation of a quasi-immobilized layer in thin films of polydimethylsiloxane (PDMS) melts near silica surfaces. This layer (40-60A) has a lower density than the bulk value, and its thickness…
Many thermal measurements in high magnetic fields require thermometers that are sensitive over a wide temperature range, are low mass, have a rapid thermal response, and have a minimal, easily correctable magnetoresistance. Here we report…
This paper is devoted to the study of photothermal transformations in multilayered structures. As a modelled sample, porous silicon with a periodic distribution of the porosity was chosen. The spatial distribution of the optical properties…
We propose the realization of capacitive temperature sensors based on the concept of displacement amplification. Our design features two high coefficient of thermal expansion (CTE) metallic layers separated by a low-CTE dielectric layer;…
Two-dimensional transition metal dichalcogenides (TMDCs), as promising alternative plasmonics supporting materials to graphene, exhibit potential applications in sensing. Here, we propose an ultrasensitive, accurate long-range surface…
Thermally-tuning silicon micro-cavities are versatile and beneficial elements in low-cost large-scale photonic integrated circuits (PICs). Traditional metal heaters used for thermal tuning in silicon micro-cavities usually need a thick SiO2…
We have developed a new micro-fabricated platform for the measurement of the specific heat of low heat capacity mg-sized metallic samples, such as superconductors, down to temperatures of as low as $10\,\mathrm{mK}$. It addresses…
Surface plasmon resonance (SPR) sensors built on photonic crystal fibers (PCFs) have recently become a promising category of optical sensing platforms. This is primarily due to their high sensitivity, compact structural design and ability…
The microelectronics industry is pushing the fundamental limit on the physical size of individual elements to produce faster and more powerful integrated chips. These chips have nanoscale features that dissipate power resulting in nanoscale…
This study has successfully demonstrated a novel self-heating formaldehyde gas sensor based on a thin film of NiO sensing layer. A new fabrication process has been developed in which the Pt micro heater and electrodes are deposited directly…
Heat exchangers are made of metals because of their high heat conductivity and mechanical stability. Metal surfaces are inherently hydrophilic, leading to inefficient filmwise condensation. It is still a challenge to coat these metal…