Related papers: Luminosity Measurement at the International Linear…
For both the FCC-ee and the ILC, to exploit properly the respective precision physics program, the theoretical precision tag on the respective luminosity will need to be improved from the analogs of the $ 0.054 \% (0.061\%)$ results at LEP…
One option at the International Linear Collider is to convert the electron beams into high energy photon beams by Compton scattering a few millimetres in front of the interaction region. Selected physics channels for this option have been…
An important technological step towards the realization of an ultra-granular hadronic calorimeter to be used in the future International Linear Collider (ILC) experiments has been made. A 33X50 cm2 GRPC detector equipped with a power-pulsed…
The International Linear Collider Technical Design Report (TDR) describes in four volumes the physics case and the design of a 500 GeV centre-of-mass energy linear electron-positron collider based on superconducting radio-frequency…
The Compact Linear Collider (CLIC) is a TeV-scale high-luminosity linear $e^+e^-$ collider under development at CERN. Following the CLIC conceptual design published in 2012, this report provides an overview of the CLIC project, its current…
Although the LHC experiments have searched for and excluded many proposed new particles up to masses close to 1 TeV, there are many scenarios that are difficult to address at a hadron collider. This talk will review a number of these…
This paper describes the design and construction of a Cherenkov detector conceived with regard to high energy Compton polarimeters for the International Linear Collider, where beam diagnostic systems of unprecedented precision must…
The prospects for electroweak precision measurements at the Future Circular Collider with electron-positron beams (FCC-ee) are discussed. The Z mass and width, as well as the value of the electroweak mixing angle, can be measured with very…
Hard photons well above 100 GeV have to be generated in a future photon-collider which essentially will be based on the infrastructure of the planned International Linear Collider (ILC). The energy of near-infrared laser photons will be…
The Compact Linear Collider, CLIC, is a proposed e$^+$e$^-$ collider at the TeV scale whose physics potential ranges from high-precision measurements to extensive direct sensitivity to physics beyond the Standard Model. This document…
The possibility of increasing the luminosity for the ILC at Ecm < 350 GeV centre-of-mass by increasing the beam power are considered. It will be shown that an approximately constant luminosity can be achieved across the centre of mass…
A prototype Silicon-Tungsten electromagnetic calorimeter (ECAL) for an International Linear Collider (ILC) detector was installed and tested during summer and autumn 2006 at CERN. The detector had 6480 silicon pads of dimension 1x1 cm^2.…
Collimator wakefields in the Beam Delivery System (BDS) of future linear colliders, such as the International Linear Collider (ILC) and the Compact Linear Collider (CLIC), can be an important source of emittance growth and beam jitter…
I discuss the motivations for, and the status of, precision calculations for the Large Hadron Collider (LHC) and the planned International Linear Collider (ILC).
An electron/positron linear collider with a center-of-mass energy between 0.5 and 1 TeV would be an important complement to the physics program of the LHC in the next decade. The Next Linear Collider (NLC) is being designed by a US…
Lepton scattering is an established ideal tool for studying inner structure of small particles such as nucleons as well as nuclei. As a future high energy nuclear physics project, an Electron-ion collider in China (EicC) has been proposed.…
Precise knowledge of all beam parameters is crucial to fully exploit the physics potential of the International Linear Collider (ILC). A sufficiently accurate measurement of the beam polarisation can only be achieved using dedicated high…
In order to fully exploit the physics potential of the ILC, it will be necessary to measure (and control) beam parameters to a permille level precision. In case of the beam polarisation, this can only be achieved with dedicated high energy…
A precision luminosity measurement is essential for LHC cross-section measurements to determine fundamental parameters of the standard model and constrain or discover beyond-the-standard-model phenomena. The luminosity of the CMS detector…
Various types of electroweak-interacting particles, which have non-trivial charges under the $\mathrm{SU}(2)_L \times \mathrm{U}(1)_Y$ gauge symmetry, appear in various extensions of the Standard Model. These particles are good targets of…