Related papers: A New System Noise Measurement Method Using a 2-bi…
A low noise constant current source used for measuring the $1/f$ noise in disordered systems in ohmic as well as non-ohmic regime is described. The source can supply low noise constant current starting from as low as 1 $\mu$A to a few tens…
Analog-to-digital conversion (ADC) is a key bottleneck in scaling DSP-centric receiver architectures to multiGigabit/s speeds. Recent information-theoretic results, obtained under ideal channel conditions (perfect synchronization, no…
Photo-induced forces can be used to manipulate and cool the mechanical motion of oscillators. When the oscillator is used as a force sensor, such as in atomic force microscopy, active feedback is an enticing route to enhancing measurement…
The noise of a device under test (DUT) is measured simultaneously with two instruments, each of which contributes its own background. The average cross power spectral density converges to the DUT power spectral density. This method enables…
We develop Johnson noise thermometry applicable to mesoscopic devices with variable source impedance with high bandwidth for fast data acquisition. By implementing differential noise measurement and two-stage impedance matching, we…
A tabletop low-noise differential amplifer with a bandwidth of 100 kHz is presented. Low voltage drifts of the order of 100 nV/day are reached by thermally stabilizing relevant amplifer components. The input leakage current is below 100 fA.…
ADCs sit at the interface of the analog and digital worlds and fundamentally determine what information is available in the digital domain for processing. This paper shows that a configurable ADC can be designed for signals with non…
The quantum rectification effect observed on asymmetric superconducting loops is proposed to use as a basic of a noise detector with maximum sensitivity. The measurements show that a critical amplitude of noise or ac current decreases down…
The phase noise of low-noise oscillators is conventionally measured by the cross-spectrum method (CSM), which has a complicated setup. We developed an alternative method called zero-crossing analysis with a double recorder setup (ZCA-DRS)…
Digital/Analog converters based on sigma-delta modulation are simple and unexpensive circuits featuring a signal bandwidth limited by speed constraints. Multi-bit modulators allow balancing complexity and speed by reducing the clock…
In this paper, we investigate the relationship between the dynamic range and quantization noise power in modulo analog-to-digital converters (ADCs). Two modulo ADC systems are considered: (1) a modulo ADC which outputs the folded samples…
Millimeter wave systems suffer from high power consumption and are constrained to use low resolution quantizers --digital to analog and analog to digital converters (DACs and ADCs). However, low resolution quantization leads to reduced data…
Thermal equilibrium states are exponentially hard to distinguish at very low temperatures, making equilibrium quantum thermometry in this regime a formidable task. We present a thermometric scheme that circumvents this limitation, by using…
The electronics of the LUX-ZEPLIN (LZ) experiment, the 10-tonne dark matter detector to be installed at the Sanford Underground Research Facility (SURF), consists of low-noise dual-gain amplifiers and a 100-MHz, 14-bit data acquisition…
We describe an AC method for the measurement of the longitudinal (Sxx) and transverse (Sxy, i.e. Nernst) thermopower of mm-size single crystal samples at low temperatures (T<1 K) and high magnetic fields (B>30 T). A low-frequency (33 mHz)…
By exploiting noise as an information-bearing resource, noise-driven communication offers a promising framework for low-complexity and secure wireless system design. In this letter, the scheme of ternary noise modulation (T-NoiseMod) is…
We develop a system for measurements of power spectra of transmitted light intensity fluctuations, in which the extraneous noise, including shot noise, is reduced. In essence, we just apply light, measure the power of the transmitted light…
In gate-defined quantum dot systems, the conductance change of electrostatically coupled sensor dots allows the observation of the quantum dots' charge and spin states. Therefore, the sensor dot must be optimally sensitive to changes in its…
We investigate massive multiple-input-multiple output (MIMO) uplink systems with 1-bit analog-to-digital converters (ADCs) on each receiver antenna. Receivers that rely on 1-bit ADC do not need energy-consuming interfaces such as automatic…
Noise and errors are unavoidable in any realistic quantum process, including processes designed to reduce noise and errors in the first place. In particular, quantum thermodynamical protocols for cooling can be significantly affected,…