Related papers: Golden Coded Multiple Beamforming
Multiple input multiple output (MIMO) precoding is an efficient scheme that may significantly enhance the communication link. However, this enhancement comes with a cost. Many precoding schemes require channel knowledge at the transmitter…
This paper proposes a highly efficient global coded-multiplexing scheme, conceptualized as Orthogonal Frequency Division Multiplexing over a finite field (FF-OFDM), for reliable multiuser communications. By utilizing a prime length cyclic…
Opportunistic scheduling and beamforming schemes have been proposed previously by the authors for reduced-feedback MIMO-OFDMA downlink systems where the MIMO channel of each subcarrier is decomposed into layered spatial subchannels. It has…
Hybrid beamforming is considered a key enabler to realize millimeter wave (mmWave) multiple-input multiple-output (MIMO) communications due to its capability of considerably reducing the number of costly and power-hungry radio frequency…
This paper introduces an innovative quantum-inspired method for beamforming (BF) optimization in multiple-input multiple-output (MIMO) arrays. The method leverages the simulated bifurcation (SB) algorithm to address the complex…
In this paper we estimate the performance of 2*4 MIMO-MC-CDMA system using convolution code in MATLAB which highly reduces BER. MC-CDMA (Multi Carrier Code Division for Multiple Access) is a multiuser and multiple access system which is…
Optimal modulation (OM) schemes for Gaussian channels with peak and average power constraints are known to require nonuniform probability distributions over signal points, which presents practical challenges. An established way to map…
Optimal binary labelings, input distributions, and input alphabets are analyzed for the so-called bit-interleaved coded modulation (BICM) capacity, paying special attention to the low signal-to-noise ratio (SNR) regime. For 8-ary pulse…
Optimal binary labelings, input distributions, and input alphabets are analyzed for the so-called bit-interleaved coded modulation (BICM) capacity, paying special attention to the low signal-to-noise ratio (SNR) regime. For 8-ary pulse…
Interference widely exists in communication systems and is often not optimally treated at the receivers due to limited knowledge and/or computational burden. Evolutions of receivers have been proposed to balance complexity and spectral…
We consider the problem of optimally decoding a quantum error correction code -- that is to find the optimal recovery procedure given the outcomes of partial "check" measurements on the system. In general, this problem is NP-hard. However,…
To fully support vertical industries, 5G and its corresponding channel coding are expected to meet requirements of different applications. However, for applications of 5G and beyond 5G (B5G) such as URLLC, the transmission latency is…
This paper addresses the performance of bit-interleaved coded multiple beamforming (BICMB) [1], [2] with imperfect knowledge of beamforming vectors. Most studies for limited-rate channel state information at the transmitter (CSIT) assume…
The Golden space-time trellis coded modulation (GST-TCM) scheme was proposed in \cite{Hong06} for a high rate $2\times 2$ multiple-input multiple-output (MIMO) system over slow fading channels. In this letter, we present the performance…
Consider the single-group multicast beamforming problem, where multiple users receive the same data stream simultaneously from a single transmitter. The problem is NP-hard and all existing algorithms for the problem either find suboptimal…
The expected operating scenarios of 5G pose a great challenge to orthogonal frequency division multiplexing (OFDM) which has poor out of band (OoB) spectral properties, stringent synchronization requirements, and large symbol duration.…
Full-rate (FR) and full-diversity (FD) are attractive features in MIMO systems. We refer to systems which achieve both FR and FD simultaneously as FRFD systems. Non-orthogonal STBCs can achieve FRFD without feedback, but their ML decoding…
In a wireless storage system, having to communicate over a fading channel makes repair transmissions prone to physical layer errors. The first approach to combat fading is to utilize the existing optimal space-time codes. However, it was…
Scheduling to avoid packet collisions is a long-standing challenge in networking, and has become even trickier in wireless networks with multiple senders and multiple receivers. In fact, researchers have proved that even {\em perfect}…
Efficient constellation design is important for improving performance in communication systems. The problem of multidimensional constellation design has been studied extensively in the literature in the context of multidimensional coded…