Related papers: Systematic Correction for "Demonstration of the Ca…
We comment on a recently published measurement of the Casimir force for distances in the 0.6 to 6 micrometer range between two Au surfaces (Phys. Rev. Lett. 78, 5(1997)) and the net discrepancy reported for the comparison with theoretical…
We consider detailed roughness and conductivity corrections to the Casimir force in the recent Casimir force measurement employing an Atomic Force Microscope. The roughness of the test bodies-a metal plate and a sphere- was investigated…
The Casimir force between two metallic plates is affected by their roughness state. This effect is usually calculated through the so-called `proximity force approximation' which is only valid for small enough wavevectors in the spectrum of…
We calculate the roughness correction to the Casimir effect in the parallel plates geometry for metallic plates described by the plasma model. The calculation is perturbative in the roughness amplitude with arbitrary values for the plasma…
We report an improved precision measurement of the Casimir force. The force is measured between a large Al coated sphere and flat plate using an Atomic Force Microscope. The primary experimental improvements include the use of smoother…
We investigate the possibility of measuring the thermal Casimir force and its gradient in the configuration of a plate and a microfabricated cylinder attached to a micromachined oscillator. The Lifshitz-type formulas in this configuration…
Quantum theory predicts the existence of the Casimir force between macroscopic bodies, due to the zero-point energy of electromagnetic field modes around them. This quantum fluctuation-induced force has been experimentally observed for…
We propose a definitive test of whether plates involved in Casimir experiments should be modeled with ballistic or diffusive electrons--a prominent controversy highlighted by a number of conflicting experiments. The unambiguous test we…
We have used an atomic force microscope to make precision measurements of the Casimir force between a metallized sphere of diameter 196 microns and flat plate. The force was measured for plate-sphere separations from 0.1 to 0.9 microns. The…
We compare theory and experiment in the Casimir force measurement between gold surfaces performed with the atomic force microscope. Both random and systematic experimental errors are found leading to a total absolute error equal to 8.5 pN…
We discuss theoretical predictions for the thermal Casimir force and compare them with available experimental data. Special attention is paid to the recent claim of the observation of that effect, as predicted by the Drude model approach.…
We report an improved dynamic determination of the Casimir pressure between two plane plates obtained using a micromachined torsional oscillator. The main improvements in the current experiment are a significant suppression of the surface…
The impact of imperfections, which are always present on surfaces of lenses with centimeter-size curvature radii, on the Casimir force in the lens-plate geometry is investigated. It is shown that the commonly used formulation of the…
We report an improved precision measurement of the Casimir force using metallic gold surfaces. The force is measured between a large gold coated sphere and flat plate using an Atomic Force Microscope. The use of gold surfaces removes some…
We discuss a proposal to measure the Casimir force in the parallel plate configuration in the $1-10\mu$m range via a high-sensitivity torsional balance. This will allow to measure the thermal contribution to the Casimir force therefore…
We have performed a precise experimental determination of the Casimir pressure between two gold-coated parallel plates by means of a micromachined oscillator. In contrast to all previous experiments on the Casimir effect, where a small…
We show that the Casimir force gradient can be quantitatively measured with no contact involved. Results of the Casimir force measurement with systematic uncertainty of 3% are presented for the distance range of 100-600 nm. The statistical…
We present results on the determination of the differential Casimir force between an Au-coated sapphire sphere and the top and bottom of Au-coated deep silicon trenches performed by means of the micromechanical torsional oscillator in the…
We propose a new theory of thermal Casimir effect, holding for the experimentally important case of metallic surfaces with a roughness having a spatial scale smaller than the skin depth. The theory is based on a simple phenomenological…
The Casimir force is calculated analytically for configurations of two parallel plates and a spherical lens (sphere) above a plate with account of nonzero temperature, finite conductivity of the boundary metal and surface roughness. The…