Related papers: Stabilizing the forming process in unipolar resist…
The conventional two transistor astable multivibrator has been modified to produce better waveform which are more steeply rising and falling than those from the conventional astable. The improvement in the waveform is achieved by using a…
We study the patterns at which the current flow stabilizes in a 1D superconducting wire, for various experimentally reasonable boundary conditions, for small fixed current densities and temperatures close to $T_c$. We pay special attention…
When grid-forming (GFM) inverter-based resources (IBRs) face severe grid disturbances (e.g., short-circuit faults), the current limitation mechanism may be triggered. Consequently, the GFM IBRs enter the current-saturation mode, inducing…
This paper develops an inductive power transfer(IPT)system with stable output power based on a Class E/EF inverter. Load-independent design of Class E/EF inverter has recently attracted widespread interest. However, applying this design to…
At a composition far above the percolation threshold, the resistance of a composite sample increases with time due to Joule heating as a constant current of sufficiently large value is passed through the sample. If the current is less than…
This work develops a constraint-aware grid-forming (GFM) control that explicitly accounts for current limits and modulation limits within the GFM oscillator dynamics generating the GFM voltage reference (i.e., phase angle and magnitude).…
Grid-forming (GFM) converters face significant challenges in limiting current during transient grid events while preserving their grid-forming behavior. This paper offers an elegant solution to the problem with a priori guarantees,…
An LCL filter offers superior attenuation for high-frequency harmonics for three-phase grid-following inverters compared to LC and L filters. However, it also introduces an inherent resonance peak, which can lead to power quality issues or…
Co(x nm, x=10nm or 40nm)/Cu(5nm)/Co(2.5nm) layers were deposited between copper electrodes in SiO2 vias. Magnetic states, and the corresponding resistance states, of these devices were switched by electric currents perpendicular to the…
The conditions for the excitation of current and voltage oscillations in the plasma of a three-electrode current and voltage stabilizer are experimentally investigated. It was found that in the regimes under consideration, the plasma has…
Inverter-based resources (IBRs) are a key component in the ongoing modernization of power systems, with grid-forming (GFM) inverters playing a central role. Effective fault current limiting is a major challenge to modernizing power systems…
We describe a calibration setup for the transresistance of low-current amplifiers, based on the capacitance-charging method. The calibration can be performed in the current range of typical interest for electron counting experiments. The…
This paper studies the problem of stabilizing a leader-follower formation specified by a set of bearing constraints and being disturbed by some unknown uniformly bounded disturbance{s}. A set of leaders are positioned at their desired…
We discuss memory effects in the conductance of hopping insulators due to slow rearrangements of structural defects leading to formation of polarons close to the electron hopping states. An abrupt change in the gate voltage and…
We have measured the transition process from the high to low resistivity states, i.e., the reset process of resistive switching based memristors based on Ni/HfO2/Si-n+ structures, and have also developed an analytical model for their…
This paper introduces the notion of an Input Constrained Control Barrier Function (ICCBF), as a method to synthesize safety-critical controllers for non-linear control affine systems with input constraints. The method identifies a subset of…
The influence of a superconducting fault current limiter (FCL) on the transient stability of the synchronic operation of electric machines is analyzed for different locations of the inductive FCL in a network and for different parameters of…
A solution to the stability of capacitor-less low-dropout regulators with a 4pF Miller capacitor in Multi-level current amplifier is proposed. With the Miller compensation, a more than 50{\deg}phase margin is guaranteed in full load. An…
Grid-forming (GFM) inverter-based resources (IBRs) are capable of emulating the external characteristics of synchronous generators (SGs) through the careful design of the control loops. However, the current limiter in the control loops of…
The ISAC polarized beam facility uses a Ti:Sapphire laser for producing spin-polarized beams of short-lived radioactive isotopes, initially 7Li. The laser power and spectral content must be tightly controlled and monitored. The control…