Related papers: Homogeneous Cu-Fe super saturated solid solutions …
Fe-Cr binary alloys serve as simplified model systems to study irradiation damage relevant to fusion structural materials. Here, Fe-3%Cr and Fe-5%Cr samples were irradiated with 4 MeV Fe ions under a dose rate of 4x10^5 dpa/s across a…
To study the size and strain rate dependency of copper polycrystalline microstructures, a multi-layered copper/Al$_2$O$_3$ thin film was deposited on a Si substrate using a hybrid deposition system (combining physical vapour and atomic…
Numerical simulations are used in this work to investigate aspects of microstructure and microsegregation during rapid solidification of a Ni-based superalloy in a laser powder bed fusion additive manufacturing process. Thermal modeling by…
Solid-state amorphization of crystalline copper nanolayers embedded in a Cu64Zr36 metallic glass is studied by molecular dynamics simulations for different orientations of the crystalline layer. We show that solid-state amorphization is…
Searching for high-performance thermoelectric (TE) materials in the paradigm of narrow-bandgap semiconductors has lasted for nearly 70 years and is obviously hampered by a bottleneck of research now. Here we report on the discovery of a few…
The influence of grain size on the flow stress of various FCC polycrystals (Cu, Al, Ag and Ni) has been analyzed by means of computational homogenization of a representative volume element of the microstructure using a FFT approach in…
We report the studies of ultrafast electron nanocrystallography on size-selected Au nanoparticles (2-20 nm) supported on a molecular interface. Reversible surface melting, melting, and recrystallization were investigated with dynamical…
Tungsten is the main candidate material for plasma-facing armour components in future fusion reactors. In-service, fusion neutron irradiation creates lattice defects through collision cascades. Helium, injected from plasma, aggravates…
Understanding the particle-scale transition from elastic deformation to plastic flow is central to making predictions about the bulk material properties and response of disordered materials. To address this issue, we perform experiments on…
Irradiation of cuprate high-$T_c$ superconductors with light ions of moderate energy creates point defects that lead to a reduction or full suppression of the critical temperature. By shaping the ion flux with a stencil mask, nanostructures…
Ultrafine-grained Al alloys produced by high pressure torsion are found to exhibit a very high strength, considerably exceeding the Hall-Petch predictions for the ultrafine grains. The phenomena can be attributed to the unique combination…
Atomic structure of a mono-dispersive hematite ($\alpha$-Fe$_2$O$_3$) nanocube $(0 1\bar1 2)$ surface was determined with synchrotron X-ray diffraction. The $\alpha$-Fe$_2$O$_3$ nanocubes were prepared through a hydrothermal process and a…
When ultrathin metal films are subjected to multiple cycles of rapid melting and resolidification by a ns pulsed laser, spatially correlated interfacial nanostructures can result from a competition among several possible thin film…
The scope of this article is to report very detailed results of the measurements of magnetic relaxation phenomena in the new Cu$_{0.5}$Fe$_{2.5}$O$_{4}$ nanoparticles and known CuFe$_{2}$O$_{4}$ nanoparticles. The size of synthesized…
Understanding the evolution of dislocation structures during plastic deformation is critical for predicting the mechanical performance of metallic materials. In this work, we applied in situ scanning electron microscopy/electron backscatter…
Ultrafast lattice deformation of tens to hundreds of nanometer thick metallic crystals, after femtosecond laser excitation, was measured directly using 8.04 keV subpicosecond x-ray and 59 keV femtosecond electron pulses. Coherent phonons…
Collisions between amorphous Fe nanoparticles were studied using molecular-dynamics simulation. For head-on collisions of nanoparticles with radii $R =$ 1.4 nm, $R =$ 5.2 nm, and $R =$ 11 nm, sticking was observed at all simulated…
The present paper studies non-uniform plastic deformations of crystals undergoing anti-plane constrained shear. The asymptotically exact energy density of crystals containing a moderately large density of excess dislocations is found by the…
New forms of carbon-based materials have received great attention, and the developed materials have found many applications in nanotechnology. Interesting novel carbon structures include the carbon peapods, which are comprised of fullerenes…
In condensed matter, scattering processes determine the transport of charge carriers. In case of heterostructures, interfaces determine many dynamic properties like charge transfer and transport and spin current dynamics. Here we discuss…