Related papers: Minimum Variance Multi-Frequency Distortionless Re…
To develop a low-complexity multicast beamforming method for millimeter wave communications, we first propose a channel gain estimation method in this article. We use the beam sweeping to find the best codeword and its two neighboring…
Full Duplex (FD) communication can revolutionize wireless communications as it avoids using independent channels for bi-directional communications. This work generalizes the point-to-point FD communication in millimeter wave (mmWave) band…
Hybrid analog and digital beamforming (HBF) has recently emerged as an attractive technique for millimeter-wave (mmWave) communication systems. It well balances the demand for sufficient beamforming gains to overcome the propagation loss…
Communication systems at millimeter-wave (mmW) and sub-terahertz frequencies are of increasing interest for future high-data rate networks. One critical challenge faced by phased array systems at these high frequencies is the efficiency of…
We propose a comprehensive scheme for realizing a massive multiple-input multiple-output (MIMO) system with dual-polarized antennas in frequency division duplexing (FDD) mode. Employing dual-polarized elements in a massive MIMO array has…
Radio Frequency Fingerprint Identification (RFFI) has emerged as a pivotal task for reliable device authentication. Despite advancements in RFFI methods, background noise and intentional modulation features result in weak energy and subtle…
We experimentally validate a mode-dependent loss (MDL) estimation technique employing acorrection factor to remove the MDL estimation dependence on the SNR when using a minimum meansquare error (MMSE) equalizer. A reduction of the MDL…
Fifth generation (5G) cellular standards are set to utilize millimeter wave (mmWave) frequencies, which enable data speeds greater than 10 Gbps and sub-centimeter localization accuracy. These capabilities rely on accurate estimates of the…
The robust adaptive beamforming design problem based on estimation of the signal of interest steering vector is considered in the paper. In this case, the optimal beamformer is obtained by computing the sample matrix inverse and an optimal…
In sensor array beamforming methods, a class of algorithms commonly used to estimate the position of a radiating source, the diagonal loading of the beamformer covariance matrix is generally used to improve computational accuracy and…
Orthogonal time frequency space modulation is a two dimensional (2D) delay-Doppler domain waveform. It uses inverse symplectic Fourier transform (ISFFT) to spread the signal in time-frequency domain. To extract diversity gain from 2D…
To enable user diversity and multiplexing gains, a fully digital precoding multiple input multiple output (MIMO) architecture is typically applied. However, a large number of radio frequency (RF) chains make the system unrealistic to…
Programmable metasurfaces promise a great potential to construct low-cost phased array systems due to the capability of elaborate modulation over electromagnetic (EM) waves. However, they are in either reflective or transmissive mode, and…
A novel method for correcting the effect of nonlinear distortion in orthogonal frequency division multiplexing signals is proposed. The method depends on adaptively selecting the distortion over a subset of the data carriers, and then using…
Delay-Doppler alignment modulation (DDAM) is a novel technique to mitigate time-frequency doubly selective channels by leveraging the high spatial resolution offered by large antenna arrays and multi-path sparsity of millimeter wave…
In full-duplex millimeter-wave (mmWave) systems, the effects of beam squint and the frequency-selectivity of self-interference exacerbate over wide bandwidths. This complicates the use of beamforming to cancel self-interference when…
A novel dynamic hybrid beamforming architecture is proposed to achieve the spatial multiplexing-power consumption tradeoff for near-field multiple-input multiple-output (MIMO) networks, where each radio frequency (RF) chain is connected to…
In mixed near-field and far-field systems, the nonorthogonality between near-field and far-field channels may cause severe inter-user interference and hence degrade rate performance, when the analog beamforming is designed based on the…
This paper considers the discrete Fourier transform (DFT) based hybrid beamforming multiuser system and studies the use of analog beam selection schemes. We first analyze the uplink ergodic achievable rates of the zero-forcing (ZF) receiver…
Phase noise and frequency offsets are due to their time-variant behavior one of the most limiting disturbances in practical OFDM designs and therefore intensively studied by many authors. In this paper we present a generalized framework for…