Related papers: Sidelobe Suppression for Robust Beamformer via The…
Applying a sparse constraint on the beam pattern has been suggested to suppress the sidelobe level of a minimum variance distortionless response (MVDR) beamformer. In this letter, we introduce a weighted sparse constraint in the beamformer…
In this paper, we focus on the design of the transmit waveforms of a frequency diverse array (FDA) in order to improve the output signal-to-interference-plus-noise ratio (SINR) in the presence of signal-dependent mainlobe interference.…
High sidelobe level is a major disadvantage of the Capon beamforming. To suppress the sidelobe, this paper introduces a mainlobe to sidelobe power ratio constraint to the Capon beamforming. it minimizes the sidelobe power while keeping the…
High sidelobe level and direction of arrival (DOA) estimation sensitivity are two major disadvantages of the Capon beamforming. To deal with these problems, this paper gives an overview of a series of robust Capon beamforming methods via…
Beamformers often trade off white noise gain against the ability to suppress interferers. With distributed microphone arrays, this trade-off becomes crucial as different arrays capture vastly different magnitude and phase differences for…
A well-known challenge in beamforming is how to optimally utilize the degrees of freedom (DoF) of the array to design a robust beamformer, especially when the array DoF is limited. In this paper, we leverage the tool of constrained convex…
A new method for the design of linear-phase robust far-field broadband beamformers using constrained optimization is proposed. In the method, the maximum passband ripple and minimum stopband attenuation are ensured to be within prescribed…
Delay-and-Sum (DAS) is the most common algorithm used in photoacoustic (PA) image formation. However, this algorithm results in a reconstructed image with a wide mainlobe and high level of sidelobes. Minimum variance (MV), as an adaptive…
We investigate an alternative solution method to the joint signal-beamformer optimization problem considered by Setlur and Rangaswamy[1]. First, we directly demonstrate that the problem, which minimizes the received noise, interference, and…
The feasibility of sparse signal reconstruction depends heavily on the inter-atom interference of redundant dictionary. In this paper, a semi-blindly weighted minimum variance distortionless response (SBWMVDR) is proposed to mitigate the…
Multiple-Input Multiple-Output (MIMO) radars provide various advantages as compared to conventional radars. Among these advantages, improved angular diversity feature is being explored for future fully autonomous vehicles. Improved angular…
Reconfigurable intelligent surface (RIS) technology is receiving significant attention as a key enabling technology for 6G communications, with much attention given to coverage infill and wireless power transfer. However, relatively little…
Since space-domain information can be utilized, microphone array beamforming is often used to enhance the quality of the speech by suppressing directional disturbance. However, with the increasing number of microphone, the complexity would…
Multiple-input multiple-output (MIMO) radars transmit a set of sequences that exhibit small cross-correlation sidelobes, to enhance sensing performance by separating them at the matched filter outputs. The waveforms also require small…
In this paper, a novel robust beamforming scheme is proposed in three dimensional multi-input multi-output (3D-MIMO) systems. As one of the typical deployments of massive MIMO, a 3D-MIMO system owns sparse channels in angular domain. Thus,…
Collaborative beamforming (CB) is a power efficient method for data communications in wireless sensor networks (WSNs) which aims at increasing the transmission range in the network by radiating the power from a cluster of sensor nodes in…
In this paper, we propose a novel waveform design for multi-input multi-output (MIMO) dual-functional radar-communication systems by taking the range sidelobe control into consideration. In particular, we focus on optimizing the weighted…
In this letter, we consider optimal hybrid beamforming design to minimize the transmission power under individual signal-to-interference-plus-noise ratio (SINR) constraints in a multiuser massive multiple-input-multiple-output (MIMO)…
This paper considers several linear beamformer design paradigms for multiuser time-invariant multiple-input multiple-output interference channels. Notably, interference alignment and sum-rate based algorithms such as the maximum…
The sample matrix inversion (SMI) beamformer implements Capon's minimum variance distortionless (MVDR) beamforming using the sample covariance matrix (SCM). In a snapshot limited environment, the SCM is poorly conditioned resulting in a…