Related papers: High-speed phonon imaging using frequency-multiple…
We demonstrate a method to perform spectroscopy of near-infrared single photons without the need of dispersive elements. This method is based on a photon energy resolving transition edge sensor and is applied for the characterization of…
Opto-mechanical systems have enabled wide-band optical frequency conversion and multi-channel all-optical radio frequency amplification. Realization of an on-chip silicon communication platform is limited by photodetectors needed to convert…
We report a high Responsivity broad band photo-detector working in the wavelength range 400 nm to 1100 nm in a horizontal array of Si microlines (line width ~1 micron) fabricated on a Silicon-on-Insulator (SOI) wafer. The array was made…
Semiconductor devices favor high carrier mobility for reduced Joule heating and high thermal conductivity for rapid heat dissipation. The ability to accurately characterize the motion of charge carriers and heat carriers is necessary to…
A prototype of digital frequency multiplexing electronics allowing the real time monitoring of kinetic inductance detector (KIDs) arrays for mm-wave astronomy has been developed. It requires only 2 coaxial cables for instrumenting a large…
The vibrational and electronic properties of 2-dimensinal (2D) materials can be efficiently tuned by external strain due to their good stretchability. Resonant Raman spectroscopy is a versatile tool to study the physics of phonons,…
Phonon reflection and transmission at the interfaces plays a fundamental role in cryogenic particle detectors, in which the optimization of the phonon signal at the sensor (in case of phonon-mediated detectors) or the minimization of the…
The "textbook" phonon mean free path (MFP) of heat carrying phonons in silicon at room temperature is ~40 nm. However, a large contribution to the thermal conductivity comes from low-frequency phonons with much longer MFPs. We present a…
Investigations into the propagation characteristics, specifically loss and wave velocity, of superconducting coplanar waveguides and microstrip lines were conducted at a 2 mm wavelength. This was achieved through the measurement of on-chip…
We report on high-efficiency superconducting nanowire single-photon detectors based on amorphous WSi and optimized at 1064 nm. At an operating temperature of 1.8 K, we demonstrated a 93% system detection efficiency at this wavelength with a…
Microwave Kinetic Inductance Detectors (MKIDs) are the most attractive radiation detectors for far-infrared and sub-mm astronomy: They combine ultimate sensitivity with the possibility to create very large detector arrays, in excess of 10…
Transient reflectivity spectroscopy is widely used to study ultrafast carrier- and phonon-dynamics in semiconductors. In their heterostructures, it is often not straightforward to distinguish contributions to the signal from the various…
We describe sensitive magnetometry using lumped-element resonators fabricated from a superconducting thin film of NbTiN. Taking advantage of the large kinetic inductance of the superconductor, we demonstrate a continuous resonance frequency…
Hybrid pixel single-photon-counting detectors have been successfully employed and widely used in Synchrotron radiation X-ray detection. In this paper, the silicon pixel sensors for single X-ray photon detection, which operate in…
In this work we demonstrate 3D imaging using two-photon excitation through a 20 cm long multimode optical fiber (MMF) of 350 micrometers diameter. The imaging principle is similar to single photon fluorescence through a MMF, except that a…
Accurate knowledge of the uneven free spectral range of an optical microresonator, which provides direct insight into group velocity dispersion, is essential for understanding and controlling Kerr frequency comb dynamics. In this work, we…
Optical frequency-comb-based-high-resolution spectrometers offer enormous potential for spectroscopic applications. Although various implementations have been demonstrated, the lack of suitable mid-infrared comb sources has impeded…
Microwave Kinetic Inductance Detectors (MKIDs) have great potential for large very sensitive detector arrays for use in, for example, sub-mm imaging. Being intrinsically readout in the frequency domain, they are particularly suited for…
Detecting spatial and temporal information of individual photons by using single-photon-detector (SPD) arrays is critical to applications in spectroscopy, communication, biological imaging, astronomical observation, and quantum-information…
We present an approach to fabrication and packaging of integrated photonic devices that utilizes waveguide and detector layers deposited at near-ambient temperature. All lithography is performed with a 365 nm i-line stepper, facilitating…