Related papers: Radio Interface for High Data Rate Wireless Sensor…
This paper introduces a novel power allocation and subcarrier optimization algorithm tailored for fixed wireless access (FWA) networks operating under low-rank channel conditions, where the number of subscriber antennas far exceeds those at…
The rapid development of IoT technology has led to a shortage of spectrum resources and energy, giving rise to simultaneous wireless information and power transfer (SWIPT) technology. However, traditional multiple input multiple output…
For the Internet of Things (IoT), there might be a large number of devices to be connected to the Internet through wireless technologies. In general, IoT devices would have various constraints due to limited processing capability, memory,…
In this study, a novel transmission scheme is proposed to serve radar-sensing and communication objectives at the same time and allocated bandwidth. The proposed transmitted frame non-orthogonally superimposes two different waveforms, which…
In this paper, we formulate and solve a weighted-sum transmitter and receiver energy minimization (WSTREMin) problem in the downlink of an orthogonal frequency division multiplexing (OFDM) based multiuser wireless system. The proposed…
The present work focus on the implementation and analyze of performance of a low-resolution OFDM system prototype with low-cost hardware. A software defined radio (SDR) system was chosen in this implementation due to its various advantages…
In this paper we present our approach regarding the implementation of new wireless radio receiver exploiting filterbank techniques, using a software-development driven approach. Since most of the common radio communications systems share a…
Resource allocation in orthogonal frequency division multiplexing (OFDM) systems is performed through allocating blocks of subcarriers to each user. Even though OFDM is the primary waveform for 5G NR systems, research reports have noted…
The Future wireless communication systems face the challenging task of simultaneously providing high quality of service (QoS) and broadband data transmission, while also minimizing power consumption, latency, and system complexity. Although…
Signal to Noise Ratio (SNR) is an important index for wireless communications. There are many methods for increasing SNR. In CDMA systems, spreading sequences are used. We consider the frequency-selective wide-sense-stationary…
With the vision of deployment of massive Internet-of-Things (IoTs) in 5G network, existing 4G network and protocols are inefficient to handle sporadic IoT traffic with requirements of low-latency, low control overhead and low power. To…
Dual-function radar-communication (DFRC) systems, which can efficiently utilize the congested spectrum and costly hardware resources by employing one common waveform for both sensing and communication (S&C), have attracted increasing…
The fifth generation wireless networks focus on the design of low latency, high data rate, high reliability, and massive connectivity communications. Non-orthogonal multiple access (NOMA) is an essential enabling technology to accommodate…
Space-Division Multiple Access (SDMA) utilizes linear precoding to separate users in the spatial domain and relies on fully treating any residual multi-user interference as noise. Non-Orthogonal Multiple Access (NOMA) uses linearly precoded…
In this paper, we investigate a distributed multi-input multi-output and orthogonal frequency division multiplexing (MIMO-OFDM) dual-function radar-communication (DFRC) system, which enables simultaneous communication and sensing in…
Signal to Noise Ratio (SNR) is an important index for wireless communications. In CDMA systems, spreading sequences are utilized. This series of papers show the method to derive spreading sequences as the solutions of the non-linear…
Of late, Software Defined Radio (SDR) approach has become an effective means to design high data rate wireless systems for a range of applications. There are methods with which low cost SDR based 4th generation (4G) or long term evolution…
Future networks are expected to connect an enormous number of nodes wirelessly using wide-band transmission. This brings great challenges. To avoid collecting a large amount of data from the massive number of nodes, computation over…
Optical wireless communication (OWC) provides high aggregate data rates in the range of Terabits per second (Tb/s). Specifically, OWC using infrared lasers as transmitters has been considered as a strong candidate in the next generation of…
One of the main open problems for next generation wireless networks, is to find the new OFDM-based waveform to be used in 5G. The new modulation scheme must primarily be able to achieve higher spectral efficiency than its predecessor. The…