Related papers: Flux noise in ion-implanted nanoSQUIDs
The measurement of the close-to-the-carrier noise of rf and microwave devices is a relevant issue in time and frequency metrology and in some fields of electronics, physics and optics. While phase noise is the main concern, amplitude noise…
Recent studies on nanoscale field-effect sensors reveal the crucial importance of the low frequency noise for determining the ultimate detection limit. In this letter, the 1/f-type noise of Si nanoribbon field-effect sensors is…
Quantum mechanics can strongly influence the noise properties of mesoscopic devices. To probe this effect we have measured the current fluctuations at high-frequency (5-90 GHz) using a superconductor-insulator-superconductor tunnel junction…
We resolve the thermal motion of a high-stress silicon nitride nanobeam at frequencies far below its fundamental flexural resonance (3.4 MHz) using cavity-enhanced optical interferometry. Over two decades, the displacement spectrum is…
Broadband noise on supercontinuum spectra generated in microstructure fiber is shown to lead to amplitude fluctuations as large as 50 % for certain input laser pulse parameters. We study this noise using both experimental measurements and…
We present a new generation of a scanning MicroSQUID microscope operating in an inverted dilution refrigerator. The MicroSQUIDs have a size of 1.21$ \ \mu$m\textsuperscript{2} and a magnetic flux sensitivity of 120 $\mu\Phi_{0} /…
The development of nonlinear and frequency-tunable superconducting microwave circuits for operation in large magnetic fields is of high relevance for hybrid quantum systems such as spin resonance spectrometers, microwave quantum magnonics,…
A superconducting quantum interference device (SQUID), functioning as a nonlinear response device, typically requires the incorporation of a flux-locked loop (FLL) circuit to facilitate linear amplification of the current signal transmitted…
We report on low-temperature noise measurements of a single electron transistor (SET) immersed in superfluid $^4$He. The device acts as a charge sensitive electrometer able to detect the fluctuations of charged defects in close proximity to…
We fabricated and tested a squelch circuit consisting of a copper powder filter with an embedded Josephson junction connected to ground. For small signals (squelch-ON), the small junction inductance attenuates strongly from DC to at least 1…
The electric noise can be an important limitation for applications of conducting elements of size in the nanometer range. The intrinsic electrical noise of prospective materials for opto-spintronics applications like ZnO has not been…
We have developed a novel dc SQUID system with a micro-coil input circuit to act as a local probe of quantum matter and nanosystems. The planar niobium micro-coil pickup loop is located remotely from the SQUID, coupled through a…
We present a new theoretical framework to analyze microwave amplifiers based on the dc SQUID. Our analysis applies input-output theory generalized for Josephson junction devices biased in the running state. Using this approach we express…
We describe a microfluidic device for studying the orientational dynamics of microrods. The device enables us to experimentally investigate the tumbling of microrods immersed in the shear flow in a microfluidic channel with a depth of 400…
Silicon carbide (SiC) is a wide band gap semiconductor and an attractive candidate for applications in harsh environments such as space, fusion, or future high luminosity colliders. Due to the large band gap, the leakage currents in SiC…
As the quantum generation of electronics takes the stage, a cast of important support electronics is needed to connect these novel devices to our classical worlds. In the case of superconducting electronics, this is a challenge because the…
We demonstrate a highly linear superconducting quantum interference device (SQUID) amplifier based on a double-loop (Bi-SQUID) architecture incorporating three superconductor-normal metal-superconductor (S-N-S) junctions. Fabricated using…
We report measurements of coherence times of an rf SQUID qubit using pulsed microwaves and rapid flux pulses. The modified rf SQUID, described by an double-well potential, has independent, in situ, controls for the tilt and barrier height…
Solid state devices for quantum bit computation (qubits) are not perfect isolated two-level systems, since additional higher energy levels always exist. One example is the Josephson flux qubit, which consists on a mesoscopic SQUID loop with…
We experimentally demonstrate the in situ tunability of the minimum energy splitting (gap) of a superconducting flux qubit by means of an additional flux loop. Pulses applied via a local control line allow us to tune the gap over a range of…