Related papers: Plasticity and reversibility of structural transit…
If a porous media is being damaged by excessive stress, the elastic matrix at every infinitesimal volume separates into a 'solid' and a 'broken' component. The 'solid' part is the one that is capable of transferring stress, whereas the…
We study the scaling properties of forced folding of thin materials of different geometry. The scaling relations implying the topological crossovers from the folding of threedimensional plates to the folding of two-dimensional sheets, and…
The quasistatic behavior of a simple 2D model of a cohesive powder under isotropic loads is investigated by Discrete Element simulations. The loose packing states, as studied in a previous paper, undergo important structural changes under…
We study the growth of slip line in a plastically deforming crystal by numerical simulation of a double-ended pile-up model with a dislocation source at one end, and an absorbing wall at the other end. In presence of defects, the pile-up…
Mechanical deformation of amorphous solids can be described as consisting of an elastic part in which the stress increases linearly with strain, up to a yield point at which the solid either fractures or starts deforming plastically. It is…
Two classes of non-linear elastic materials are derived via two-dimensional homogenization. These materials are equivalent to a periodic grid of axially-deformable and axially-preloaded structural elements, subject to incremental…
Impact of single particle onto a rigid substrate leads to its deformation and fragmentation. The flow associated with the particle spreading on a solid substrate after impact is extremely complicated. In this theoretical study a simplified…
We investigate the possibility of a striped inhomoegenous phase occurring as an electronic system with an order parameter linearly coupled to the elastic degrees of freedom is tuned through the electronic phase transition. We find that in…
Since the 1970's, theories of deformation and failure of amorphous, solidlike materials have started with models in which stress-driven, molecular rearrangements occur at localized flow defects via "shear transformations". This picture is…
Close to the yielding transition, amorphous solids exhibit a jerky dynamics characterized by plastic avalanches. The statistics of these avalanches have been measured experimentally and numerically using a variety of different triggering…
We investigate the crumpling of a sheet as it is repeatedly crushed onto itself by rolling it into a cylinder and twisting it axially while allowing the end-to-end length to evolve freely. As deduced from its plastic deformations, the sheet…
Flow-induced failure of granular materials is relevant to a broad range of geomechanical applications. Plasticity, which is the inherent failure mechanism of most granular materials, enables large deformations that can invalidate linearised…
The influence of alternating shear orientation and strain amplitude of cyclic loading on yielding in amorphous solids is investigated using molecular dynamics simulations. The model glass is represented via a binary mixture that was rapidly…
The response of amorphous materials to an applied strain can be continuous, or instead display a macroscopic stress drop when a shear band nucleates. Such discontinuous response can be observed if the initial configuration is very stable.…
Strain can affect the morphology of a crystal surface, and cause modifications of its reconstruction even when weak, as in the case of mechanical bending. We carried out calculations of strain-dependent surface free energy and direct…
We study the statistical properties of the yielding transition in model amorphous solids in the limit of slow, athermal deformation. Plastic flow occurs via alternating phases of elastic loading punctuated by rapid dissipative events in the…
Constitutive equations are derived for the viscoelastic behavior of filled elastomers at isothermal loading with finite strains. A particle-reinforced rubber is thought of as a composite where regions with low concentrations of junctions…
On microscopic and mesoscopic scales, plastic flow of crystals is characterized by large intrinsic fluctuations. Deformation by crystallographic slip occurs in a sequence of intermittent bursts ('slip avalanches') with power-law size…
The elastic backbone is the set of all shortest paths. We found a new phase transition at $p_{eb}$ above the classical percolation threshold at which the elastic backbone becomes dense. At this transition in $2d$ its fractal dimension is…
We describe a 2D spring-block model for the transition from static to kinetic friction at an elastic slider/rigid substrate interface obeying a minimalistic friction law (Amontons-Coulomb). By using realistic boundary conditions, a number…