Related papers: Investigation of mechanical losses of thin silicon…
Nanostructured silicon is a promising material for thermoelectric conversion, because the thermal conductivity in silicon nanostructures can be strongly reduced with respect to that of bulk materials. We present thermal conductivity…
The surface of an insulating material irradiated by a beam of low energy electrons charges positively if the yield of secondary electron is greater than unity. For such a dynamical equilibrium, the thermodynamic properties have been…
Accurate calculation of internal and surface scattering losses in fused silica microspheres is done. We show that in microspheres internal scattering is partly inhibited as compared to losses in the bulk material. We pay attention on the…
A molecular-dynamics thermal annealing model is proposed to investigate the mechanisms involved in picosecond pulsed laser ablation of crystalline silicon. In accordance with the thermal annealing model, a detailed description of the…
Porous materials provide a large surface to volume ratio, thereby providing a knob to alter fundamental properties in unprecedented ways. In thermal transport, porous nanomaterials can reduce thermal conductivity by not only enhancing…
This paper describes a temperature sensitivity or thermal sag measurement of a geometric anti-spring based micro-electromechanical system (MEMS) gravimeter (Wee-g). The Wee-g MEMS gravimeter is currently fabricated on a (100) silicon wafer…
The next generation of gravitational wave detectors will move to cryogenic operation in order to reduce thermal noise and thermal distortion. This necessitates a change in mirror substrate with silicon being a good candidate. Birefringence…
We report on our results for the characterization of Si:P delta-layers grown by low temperature molecular beam epitaxy. Our data shows that the effective thickness of a delta-layer can be obtained through a weak localization analysis of…
The thermal noise of mirror coatings for gravitational-wave detectors critically depends on the elastic properties of the constituent materials. Data analyses and theoretical models typically assume each material is homogeneous and…
Nowadays microfabrication techniques originating from micro-electronics enable to create mechanical objects of micron-size. The field of Micro-Electro-Mechanical devices (MEMS) is continuously expanding, with an amazingly broad range of…
The focus of this paper is the vanishing of the thermal expansion in certain diamond-like semiconductors. In silicon becomes zero at T = 122. K. In germanium the situation is less clear. Previous investigations show that in natural…
We report on an optimized micro-machined thermal flow-rate sensor as part of an autonomous multi-parameter sensing device for water network monitoring. The sensor has been optimized under the following constraints: low power consumption and…
We have measured the thermal conductivity of glassy glycerol between 1.5 K and 100 K, as well as the specific heat of both glassy and crystalline phases of glycerol between 0.5 K and 25 K. We discuss both low-temperature properties of this…
Using a realistic model, the mode Gruneisen parameters and the temperature dependent coefficient of linear thermal expansion are calculated for amorphous silicon. The resulting values of the Gruneisen parameters differ from the crystalline…
Thermal transport behavior in silicene nanotubes has become more important due to the application of these promising nanostructures in the engineering of next-generation nanoelectronic devices. We apply non-equilibrium molecular dynamics…
Boundary scattering in hierarchically disordered nanomaterials is an effective way to reduce the thermal conductivity of thermoelectric materials and increase their performance. In this work we investigate thermal transport in silicon based…
We report on the low-frequency current fluctuations and electronic noise in thin-films made of bismuth selenide topological insulators. The films were prepared via the graphene-like mechanical exfoliation and used as the current conducting…
We use extensive classical molecular dynamics simulations to calculate the thermal conductivity of a model silica glass. Apart from the potential parameters, this is done with no other adjustable quantity and the standard equations of heat…
In this paper, small-angle X-ray scattering measurements are used to determine the different compressibility contributions, as well as the isothermal compressibility, in thermal equilibrium in silica glasses having different thermal…
The performance of superconducting circuits for quantum computing is limited by materials losses. In particular, coherence times are typically bounded by two-level system (TLS) losses at single photon powers and millikelvin temperatures.…