Related papers: Discrete rearranging disordered patterns: Predicti…
A thin flat rectangular plate supported on its edges and subjected to in-plane loading exhibits stable post-buckling behaviour. However, the introduction of a nonlinear (softening) elastic foundation may cause the response to become…
Slender elastic objects such as a column tend to buckle under loads. While static buckling is well understood as a bifurcation problem, the evolution of shapes during dynamic buckling is much harder to study. Elastic rings under normal…
This study proposes a coherent scenario of the formation of permanent shear bands in the flow of yield stress materials. It is a well accepted point of view that flow in disordered media is occurring via local plastic events, corresponding…
The mechanisms of void growth and coalescence are key contributors to the ductile failure of crystalline materials. At the grain scale, single crystal plastic anisotropy induces large strain localization leading to complex shape evolutions.…
We investigate the stability and geometrically non-linear dynamics of slender rods made of a linear isotropic poroelastic material. Dimensional reduction leads to the evolution equation for the shape of the poroelastica where, in addition…
We consider a system of granular particles, modeled by two dimensional frictional elastic disks, that is exposed to externally applied time-dependent shear stress in a planar Couette geometry. We concentrate on the external forcing that…
Volume alteration in solid materials is a common cause of material failure. Here we investigate the crack formation in thin elastic layers attached to a substrate. We show that small variations in the volume contraction and substrate…
We numerically study confined channel foam flow around an obstacle using a two-dimensional bubble model, inspired by experiments performed in the same geometry. We systematically vary the polydispersity, the external driving force, and the…
Residual stress and plastic strain in additive manufactured materials can exhibit significant microscopic variation at the powder scale, profoundly influencing the overall properties of printed components. This variation depends on…
The role of plastic deformation in the high-pressure compaction of granular material is investigated using bonded particle model simulations. Grains are discretized into a set of computational particles connected by pairwise bonds. Bonds…
A number of current theories of plasticity in amorphous solids assume at their basis that plastic deformations are spatially localized. We present in this paper a series of numerical experiments to test the degree of locality of plastic…
We propose a dynamical theory of low-temperature shear deformation in amorphous solids. Our analysis is based on molecular-dynamics simulations of a two-dimensional, two-component noncrystalline system. These numerical simulations reveal…
The focus is on discrete defects that can be modeled by continuum mechanics, but where the discreteness of the carriers of plastic deformation plays a significant role. The formulations are restricted to small deformation kinematics and the…
The behavior of shear-oscillated amorphous materials is studied using a coarse-grained model. Samples are prepared at different degrees of annealing and then subject to athermal and quasistatic oscillatory deformations at various fixed…
This thesis presents a two-layer uniform facet elastic object for real-time simulation based on physics modeling method. It describes the elastic object procedural modeling algorithm with particle system from the simplest one-dimensional…
The elastic response of a two-dimensional amorphous solid to induced local shear transformations, which mimic the elementary plastic events occurring in deformed glasses, is investigated via Molecular Dynamics simulations. We show that for…
Experiments test the dependence of shearing stress on the first two gradients of shear strain. The tests were conducted by direct numerical simulation using the Discrete Element Method (DEM) on a large two-dimensional (2D) assembly of…
Two dimensional simulations of non-cohesive granular matter in a biaxial shear tester are discussed. The effect of particle elasticity on the mechanical behavior is investigated using two complementary distinct element methods (DEM): Soft…
Using discrete element simulations based on molecular dynamics, we investigate the mechanical behavior of sheared, dry, frictional granular media in the "dense" and "critical" regimes. We find that this behavior is partitioned between…
Plastic deformation of micron and sub-micron scale specimens is characterized by intermittent sequences of large strain bursts (dislocation avalanches) which are separated by regions of near-elastic loading. In the present investigation we…