Related papers: Experiments with calibrated digital sideband separ…

Rate splitting (RS) is a potentially powerful and flexible technique for multi-antenna downlink transmission. In this paper, we address several technical challenges towards its practical implementation for beyond 5G systems. To this end, we…

The wide bandwidth and large number of antennas used in millimeter wave systems put a heavy burden on the power consumption at the receiver. In this paper, using an additive quantization noise model, the effect of analog-digital conversion…

Massive multiple-input multiple-output (MIMO) is promising for low earth orbit (LEO) satellite communications due to the potential in enhancing the spectral efficiency. However, the conventional fully digital precoding architectures might…

This paper presents the design and validation of a digital receiver system developed for the next-generation radio interferometer projects. The receiver supports 8 analog inputs with 12-bit, 4GHz sampling and performs real-time signal…

For E-band wireless communications, a high gain steerable antenna with sub-arrays is desired to reduce the implementation complexity. This paper presents an E-band communication link with 256-elements antennas based on 8-elements sub-arrays…

We demonstrate a dual optical frequency comb concept that down-converts arbitrary narrowband D-band (110-170 GHz) signals to baseband without any filter or optical/RF frequency tuning, using low frequency RF components.

We present a microscope paradigm that performs differential interference imaging with high sensitivity via optical amplification and radio-frequency (RF) heterodyne detection. This method, termed differentially-enhanced sideband imaging via…

We demonstrate a design for a high-performance $2 \times 2$ splitter meeting the essential requirements of broadband coupling, support for arbitrary coupling ratio, ultra low-loss, high fabrication tolerance, and a compact footprint. This…

This paper describes digital radio astronomical receivers used for decameter and meter wavelength observations. This paper describes digital radio astronomical receivers used for decameter and meter wavelength observations. Since 1998,…

Measuring microcombs in amplitude and phase provides unique insight into the nonlinear cavity dynamics but spectral phase measurements are experimentally challenging. Here, we report a linear heterodyne technique assisted by electro-optic…

ALMA has been operating since 2011, but has not yet been populated with the full suite of intended frequency bands. In particular, ALMA Band 2 (67-90 GHz) is the final band in the original ALMA band definition to be approved for production.…

In a typical multi-standard military communication receiver, fast and reliable spectrum sensing unit is required to extract the information of multiple channels (frequency bands) present in a wideband input signal. In this paper, an energy…

Earth observing satellites carrying multi-spectral sensors are widely used to monitor the physical and biological states of the atmosphere, land, and oceans. These satellites have different vantage points above the earth and different…

Radio-frequency (RF) control is a key technique in cold atom experiments. We present a compact and efficient RF circuit based on a capacitive transformer network, where a low-frequency coil operating up to 30MHz serves as both an intrinsic…

Calibrating telescope data is one of the most important issues an observer faces. In this chapter we describe a number of the methods which are commonly used to calibrate radio telescope data in the centimeter wavelength regime. This…

In radio astronomy, accurate calibration is of crucial importance for the new generation of radio interferometers. More specifically, because of the potential presence of outliers which affect the measured data, robustness needs to be…

As the number of qubits in nascent quantum processing units increases, the connectorized RF (radio frequency) analog circuits used in first generation experiments become exceedingly complex. The physical size, cost and electrical failure…

As the maximum RF input and output frequencies of the integrated data converters in RFSoC increase, it becomes practical to digitize and synthesize RF signals in the majority of C band directly without analogue up and down mixing circuits.…

The millimeter wave (mmW) frequency spectrum has been explored recently for large bandwidth communication. At these frequencies, narrow directional beams are required for communication since the signal attenuation is high due to atmospheric…

Large-scale multiple-antenna systems have been identified as a promising technology for the next generation of wireless systems. However, by scaling up the number of receive antennas the energy consumption will also increase. One possible…