Related papers: Sidelobe Control in Collaborative Beamforming via …
In this paper, we consider a multi-cell network where every base station (BS) serves multiple users with an antenna array. Each user is associated with only one BS and has a single antenna. Assume that only long-term channel state…
This letter advances the non-orthogonal multiple access (NOMA) technique for cellular downlink co-channel interference mitigation, via exploiting the (limited) cooperation among base stations (BSs). Specifically, we consider a simplified…
Clustering in wireless sensor networks (WSNs) is an important technique to ease topology management and routing. Clustering provides an effective method for prolonging lifetime of a WSN. This paper proposes energy efficient multi-level…
Radio Spectrum is most precious and scarce resource and must be utilized efficiently and effectively. Cognitive radio is the promising solutions for the optimum utilization of the scared natural resource. The spectrum owned by the primary…
This paper introduces a wireless communication protocol for industrial control systems that uses channel quality awareness to dynamically create network-device cooperation and assist the nodes in momentary poor channel conditions. To that…
In millimeter-wave communications, multiple-input-multiple-output (MIMO) systems use large antenna arrays to achieve high gain and spectral efficiency. These massive MIMO systems employ hybrid beamformers to reduce power consumption…
This paper proposes a framework for designing robust precoders for a multi-input single-output (MISO) system that performs integrated sensing and communication (ISAC) across multiple cells and users. We use Cramer-Rao-Bound (CRB) to measure…
Existing information theoretic work in decentralized detection is largely focused on parallel configuration of Wireless Sensor Networks (WSNs), where an individual hard or soft decision is computed at each sensor node and then transmitted…
The beamforming techniques have been recently studied as possible enablers for underlay spectrum sharing. The existing beamforming techniques have several common limitations: they are usually system model specific, cannot operate with…
This paper investigates the transceiver design problem in a noisy-sensing noisy-transmission multi-input multi-output (MIMO) wireless sensor network. Consider a cluster-based network, where multiple sensors scattering across several…
Modern IEEE 802.11 (Wi-Fi) networks extensively rely on multiple-input multiple-output (MIMO) to significantly improve throughput. To correctly beamform MIMO transmissions, the access point needs to frequently acquire a beamforming matrix…
Non-orthogonal multiple access (NOMA) and millimeter wave (mmWave) are two key enabling technologies for the fifth-generation (5G) mobile networks and beyond. In this paper, we consider mmWave NOMA systems with max-min fairness constraints.…
In this paper, we describe a conceptual design methodology to design distributed neural network architectures that can perform efficient inference within sensor networks with communication bandwidth constraints. The different sensor…
The position of the base station (BS) in wireless sensor networks (WSNs) has a significant impact on network lifetime. This paper suggests a mobile BS positioning algorithm for cluster-based WSNs, which considers both the location and the…
Abstract-One-bit compressive sensing (CS) is known to be particularly suited for resource-constrained wireless sensor networks (WSNs). In this paper, we consider 1-bit CS over noisy WSNs subject to channel-induced bit flipping errors, and…
The mutual information of bit-interleaved coded modulation (BICM) systems, sometimes called the BICM capacity, is investigated at low signal-to-noise ratio (SNR), i.e., in the wideband regime. A new linear transform that depends on bits'…
This paper deals with the problem of beamforming design in a multibeam satellite, which is shared by different groups of terminals -clusters-, each served by an Earth station or gateway. Each gateway precodes the symbols addressed to its…
The integration of sensing capability in the design of wireless communication systems is foreseen as a key enabler for efficient radio resource management in next-generation networks. This paper focuses on millimeter-wave communications,…
Compressed beamforming algorithm is used in the current Wi-Fi standard to reduce the beamforming feedback overhead (BFO). However, with each new amendment of the standard the number of supported antennas in Wi-Fi devices increases, leading…
Various primary user (PU) radios have been allocated into fixed frequency bands in the whole spectrum. A cognitive radio network (CRN) should be able to perform the wideband spectrum sensing (WSS) to detect temporarily unoccupied frequency…