Related papers: Phase Noise in RF and Microwave Amplifiers
This article explains phase noise, jitter, and some slower phenomena in digital integrated circuits, focusing on high-demanding, noise-critical applications. We introduce the concept of phase type and time type phase noise. The rules for…
The microwave signal at the output of a photodiode that detects a modulated optical beam contains the phase noise phi(t) and the amplitude noise alpha(t) of the detector. Beside the white noise, which is well understood, the spectral…
An experimental study of amplitude modulation and phase modulation noise spectra in cascaded amplifiers was carried out as a function of the number of amplification stages and the input power. Flicker and white noise contributions were…
We introduce a novel measurement method for the phase noise measurement of optical amplifiers, topologically similar to the Heterodyne Mach-Zehnder Interferometer but governed by different principles, and we report on the measurement of a…
As a consequence of a general trend in the physics of oscillators and clocks towards optics, phase and frequency metrology is rapidly moving to optics too. Yet, optics is not replacing the traditional radio-frequency (RF) and microwave…
Amplification is usually necessary when measuring the frequency instability of microwave signals. In this work, we develop a flicker noise free frequency measurement system based on a common or shared amplifier. First, we show that…
The phase of an optical field inside a linear amplifier is widely known to diffuse with a diffusion coefficient that is inversely proportional to the photon number. The same process occurs in lasers which limits its intrinsic linewidth and…
The measurement of the close-to-the-carrier noise of rf and microwave devices is a relevant issue in time and frequency metrology and in some fields of electronics, physics and optics. While phase noise is the main concern, amplitude noise…
The close-in AM noise is often neglected, under the assumption that it is a minor problem as compared to phase noise. With the progress of technology and of experimental science, this assumption is no longer true. Yet, information in the…
We characterize the phase noise of a microwave photonic channel, where a 10 GHz signal is carried by an intensity-modulated light beam over a short optical fiber, and detected. Two options are compared, (i) an electro-optic modulator (EOM),…
Driven by advances in electronic technology, modern digital phasemeters have significantly improved in integration and functionality, enabling real-time measurement and analysis of dynamic signals. High-precision phase measurement is…
This article analyzes the design of a low-noise amplifier intended as the input front-end for the measurement of the low-frequency components (below 10 Hz) of a 50 Ohm source. Low residual flicker is the main desired performance. This…
This article proposes a method for the measurement of Phase Noise (PN, or PM noise) and Amplitude Noise (AN, or AM noise) of Digital-to-Analog Converters (DAC) and Direct Digital Synthesizers (DDS) based on modulation-index amplification.…
We have measured noise in thin-film superconducting coplanar waveguide resonators. This noise appears entirely as phase noise, equivalent to a jitter of the resonance frequency. In contrast, amplitude fluctuations are not observed at the…
Any quantum device that amplifies coherent states of a field while preserving their phase generates noise. A nonlinear, phase-invariant amplifier may generate less noise, over a range of input field strengths, than any linear amplifier with…
The frequency flicker of an oscillator, which appears as a 1/f^3 line in the phase noise spectral density, and as a floor on the Allan variance plot, originates from two basic phenomena, namely: (1) the 1/f phase noise turned into 1/f…
We analyze the phase-noise measurement methods in which correlation and averaging is used to reject the background noise of the instrument. All the known methods make use of a mixer, used either as a saturated phase detector or as a linear…
In fundamental papers from 1962 [1, 2], Heffener and Haus showed that it is not possible to construct a linear noiseless amplifier. The implies that the amplifier intrinsic noise sources induce random perturbations on the phase of the…
The output of oscillators is usually not stable over time. In particular, phase variations---or \emph{phase noise}---corrupts the oscillations. In this letter, we describe a circuit that designed to average the phase noise processes and…
This contribution focuses on phase-noise added during frequency conversion in low-level radio frequency (LLRF) control systems. The stability of beams' parameters in linear accelerators depends on the stability of amplitude and phase of the…