Related papers: Xampling: Analog to Digital at Sub-Nyquist Rates
This paper investigates the effect of sub-Nyquist sampling upon the capacity of an analog channel. The channel is assumed to be a linear time-invariant Gaussian channel, where perfect channel knowledge is available at both the transmitter…
The limited availability of spectrum resources has been growing into a critical problem in wireless communications, remote sensing, and electronic surveillance, etc. To address the high-speed sampling bottleneck of wideband spectrum…
In high-dynamic range (HDR) analog-to-digital converters (ADCs), having many quantization bits minimizes quantization errors but results in high bit rates, limiting their application scope. A strategy combining modulo-folding with a low-DR…
Recovering signals within limited dynamic range (DR) constraints remains a central challenge for analog-to-digital converters (ADCs). To prevent data loss, an ADCs DR typically must exceed that of the input signal. Modulo sampling has…
Xampling generalizes compressed sensing (CS) to reduced-rate sampling of analog signals. A unified framework is introduced for low rate sampling and processing of signals lying in a union of subspaces. Xampling consists of two main blocks:…
We present the design and hardware implementation of a radar prototype that demonstrates the principle of a sub-Nyquist collocated multiple-input multiple-output (MIMO) radar. The setup allows sampling in both spatial and spectral domains…
Future wireless communications systems are expected to operate at bands above 100GHz. The high energy consumption of analog-to-digital converters, due to their high resolution represents a bottleneck for future wireless communications…
From generation to generation, the maximum RF frequency and sampling rate of the integrated data converters in RF system-on-chip (RFSoC) family devices from Xilinx increases significantly. With the integrated digital mixers and up and down…
This article presents a two-stage approach for the processing of frequency-stacked mobile subbands. The frequency stacking is performed in the analog domain to enable the use of a wideband analog-to-digital converter (ADC), instead of…
Analog-to-digital converters (ADCs) play a vital important role in any devices via manipulating analog signals in a digital manner. Given that the amplitude of the signal exceeds the dynamic range of the ADCs, clipping occurs and the…
Cognitive radio (CR) requires spectrum sensing over a broad frequency band. One of the crucial tasks in CR is to sample wideband signal at high sampling rate. In this paper, we propose an acquisition receiver with co-prime sampling…
This paper studies the problem of signal tracking and disturbance rejection for sampled-data control systems, where the pertinent signals can reside beyond the so-called Nyquist frequency. In light of the sampling theorem, it is generally…
In this paper, we propose a sub-Nyquist sampling (SNS) orthogonal frequency-division multiplexing (OFDM) radar system capable of reducing the analog-to-digital converter (ADC) sampling rate in OFDM radar without any additional manipulations…
High-speed high-resolution Analog-to-Digital Conversion is the key part for waveform digitization in physics experiments and many other domains. This paper presents a new fully digital correction of mismatch errors among the channels in…
Optical communication systems, which operate at very high rates, are often limited by the sampling rate bottleneck. The optical wideband regime may exceed analog to digital converters (ADCs) front-end bandwidth. Multi-channel sampling…
Representing a continuous-time signal by a set of samples is a classical problem in signal processing. We study this problem under the additional constraint that the samples are quantized or compressed in a lossy manner under a limited…
This paper presents a dynamic predictive sampling (DPS) based analog-to-digital converter (ADC) that provides a non-uniform sampling of input analog continuous-time signals. The processing unit generates a dynamic prediction of the input…
A sample rate converter(SRC) is designed to adjust the sampling rate of digital signals flexibly for different application requirements in the broadband signal processing system. In this paper, a novel parallel-serial structure is proposed…
Analog-to-digital converters (ADCs) allow physical signals to be processed using digital hardware. Their conversion consists of two stages: Sampling, which maps a continuous-time signal into discrete-time, and quantization, i.e.,…
In this paper, we study the problem of joint wideband spectrum sensing and direction-of-arrival (DoA) estimation in a sub-Nyquist sampling framework. Specifically, considering a scenario where a few uncorrelated narrowband signals spread…