Related papers: Hie-Isolde High Beta Cavity Study and Measurements

Extending the cavity length of diode lasers with feedback from Bragg structures and ring resonators is highly effective for obtaining ultra-narrow laser linewidths. However, cavity length extension also decreases the free-spectral range of…

The injector (Scheme-I) of the C-ADS linac is a 10-mA 10-MeV proton linac working in CW mode. It is mainly comprised of a 3.2-MeV room-temperature 4-vane RFQ and twelve superconducting single-spoke cavities housed in a long cryostat. Error…

We report on the microwave properties of a resonant cylindrical cavity made of bulk MgB2 superconductor, produced by the reactive liquid Mg infiltration process. The frequency response of the cavity has been measured in the range 5-13GHz.…

The development of Ultra-High Frequency (UHF) linear accelerators via Metal Additive Manufacturing (MAM) is a strategic research focus of the RACERS team at GSI. The 704.4 MHz Crossbar H-mode (CH) cavity, proposed in 2021 to facilitate…

Dephasing induced by residual thermal photons in the readout resonator is a leading factor limiting the coherence times of qubits in the circuit QED architecture. This residual thermal population, of the order of $10^{-1}$--$10^{-3}$, is…

A process which strongly amplifies both quadrature amplitudes of an oscillatory signal necessarily adds noise. Alternatively, if the information in one quadrature is lost in phase-sensitive amplification, it is possible to completely…

We report the efficient coupling of a $50\,\Omega$ microwave circuit to a high impedance conductor. We use an impedance transformer consisting of a $\lambda/4$ co-planar resonator whose inner conductor contains an array of superconducting…

The HE-LHC study investigates the possibilities for upgrading the beam energy of the Large Hadron Collider CERN from 7 TeV to 16.5 TeV. This paper presents a preliminary investigation of intensity issues and machine protection for the…

Fermilab is planning the construction of a prototype front end of the Project X linac. The Project X Injector Experiment (PXIE) is expected to accelerate 1 mA cw H- beam up to 30 MeV. Some of the major goals of the project are to test a cw…

We present hybrid-integrated extended cavity diode lasers tunable around 637 nm, with a gain-wide spectral coverage of 8 nm. This tuning range allows addressing the zero-phonon line of nitrogen vacancy centers and includes the wavelength of…

We present the calculations for electromagnetic design of a Beta_g = 0.61, multi-cell superconducting radiofrequency cavity for the Indian Spallation Neutron Source (ISNS) project. Geometry of the mid-cells is optimized using a step by…

An introduction and the status of R&D activities for a high-resolution, "cold" beam position monitor (BPM) and the related read-out electronics are discussed. Two different BPM detector concepts, to be attached to the SC quadrupole and…

The Spallation Neutron Source (SNS) Front-End Systems Group at Lawrence Berkeley National Lab (LBNL) is developing a Radio Frequency Quadrupole (RFQ) to accelerate an H- beam from 65 keV to 2.5 MeV at the operating frequency of 402.5 MHz.…

Manipulating the electromagnetic spectrum at the single-photon level is fundamental for quantum experiments. In the visible and infrared range, this can be accomplished with atomic quantum emitters, and with superconducting qubits such…

The cavities in superconducting linacs tend to operate with narrow bandwidths that are comparable to microphonic induced detuning from external forces. Proportional-Integral (PI) feedback loops are used to stabilize the cavity voltage in…

The Proton Improvement Plan - II (PIP-II) is a new linear accelerator (LINAC) complex being built at Fermilab. It is based on superconducting radiofrequency cavities and will accelerate H- ions to 800 MeV kinetic energy before injection…

The proposed linear electron-positron collider TESLA is based on 1.3 GHz superconducting niobium cavities for particle acceleration. For a centre-of-mass energy of 500 GeV, an accelerating field of 23.4 MV/m is required which is reliably…

Increasing the Fermilab Main Injector (MI) beam power above ~1.2 MW requires replacement of the 8 GeV Booster by a higher intensity alternative. Earlier, rapid-cycling synchrotron and linac solutions were considered for this purpose. In…

Confined spin-wave modes are a promising object for studying nonlinear effects and future quantum technologies. Here, using micromagnetic simulations, we use a microwave magnetic field from a coplanar waveguide (CPW) to pump a standing…

Quantum sensing and computation can be realized with superconducting microwave circuits. Qubits are engineered quantum systems of capacitors and inductors with non-linear Josephson junctions. They operate in the single-excitation quantum…