Related papers: Fabrication of the iron-based superconducting wire…
Among the Fe-based superconductors, Fe$_{1+y}$Te$_{1-x}$Se$_{x}$ is unique in that its crystal structure is the simplest and the electron correlation level is the strongest, and thus it is important to investigate the…
Among iron based superconductors, the layered iron chalcogenide Fe(Te1-xSex) is structurally the simplest and has attracted considerable attentions. It has been speculated from bulk studies that nanoscale inhomogeneous superconductivity may…
Recent improvements in materials growth and fabrication techniques may finally allow for superconducting semiconductors to realize their potential. Here we build on a recent proposal to construct superconducting devices such as wires,…
The recent discovery and subsequent developments of FeAs-based superconductors have presented novel challenges and opportunities in the quest for superconducting mechanisms in correlated-electron systems. Central issues of ongoing studies…
The new class of Mg-B superconducting conductors was prepared using the standard in-situ powder-in-tube, PIT, method where Mg+2B mixture was used to fill the copper and silver tubes. Study of the intergranular current, grain connectivity…
Superconductivity in iron selenides has experienced a rapid growth, but not without major inconsistencies in the reported properties. For alkali-intercalated iron selenides, even the structure of the superconducting phase is a subject of…
I present a brief overview on the interplay between magnetism and superconductivity in one of the Fe-based superconductor systems, \fts, where the research of our group has centered. The parent compound Fe$_{1+y}$Te is an antiferromagnet;…
Single crystalline FeTe$_{0.61}$Se$_{0.39}$ with a sharp superconducting transition at $T_{\textrm{c}} \sim$ 14 K is synthesized via slow furnace cooling followed by low-temperature annealing. The effect of annealing on the chemical and…
Fe$_y$Te$_{1-x}$Se$_x$, an archetypical iron-based high-temperature superconductor with a simple structure but rich physical properties, has attracted lots of attention because the two end compositions, Se content $x = 0$ and 1, exhibit…
Anisotropy effects on flux pinning and flux flow are strongly effective in cuprate as well as iron-based superconductors due to their intrinsically layered crystallographic structure. However $\textrm{Fe(Se,Te)}$ thin films grown on…
Due to the simple layered structure, isostructural FeSe and FeSe0.5Te0.5 are clue compounds for understanding the principal mechanisms of superconductivity in the family of Fe-based superconductors. High-pressure magnetic, structural and…
A spin-polarized superconducting condensate generates a net magnetization with measurable signatures. We present evidence for an intrinsic magnetic field in mesoscopic Fe(Te,Se) rings. The intrinsic field, encoded in the phase of…
The recently discovered FeAs-based superconductors are a new, promising set of materials for both technological as well as basic research. They offer transition temperatures as high as 55 K as well as essentially isotropic and extremely…
We study the angular dependence of the dissipation in the superconducting state of FeSe and Fe(Se$_\text{1-x}$Te$_\text{x}$) through electrical transport measurements, using crystalline intergrown materials. We reveal the key role of the…
$MgB_2$ becomes superconducting just below 40 K. Whereas porous polycrystalline samples of $MgB_2$ can be synthesized from boron powders, in this letter we demonstrate that dense wires of $MgB_2$ can be prepared by exposing boron filaments…
In this work, we present the studies of structural phase transitions in Fe(Se,Te) crystals in the range of about 30% selenium substitution by tellurium. We found a significant change in the properties of the ordered state of these…
Complex conductivity measurements spanning the entire temperature range, including the vicinity of $T_c$, were conducted on systematically varied FeSe$_{1-x}$Te$_x$ ($x$ = 0 - 0.5) very thin films. By applying a novel cavity measurement…
Among the recently discovered iron-based superconductors, ultrathin films of FeSe grown on SrTiO3 substrates have uniquely evolved into a high superconducting-transition-temperature (TC) material. The mechanisms for the high-TC…
Ag-sheathed CaKFe4As4 superconducting tapes have been fabricated via the ex-situ powder-in-tube method. Thermal and X-ray diffraction analyses suggest that the CaKFe4As4 phase is unstable at high temperatures. It decomposes into the CaAgAs…
This paper gives a review of studies of superconductors with a porosity above 50%. The pores in such superconducting materials provide refrigerant penetration, efficient heat dissipation and stable operation. Methods for the synthesis of…