Related papers: ADC non-linear errors correction in thermal diagno…
When a quantizer input signal is the sum of the desired signal and input white noise, the quantization error is a function of total input signal. Our new equivalent model splits the quantization error into two components: a non-linear…
Interferometric gravitational-wave detectors like LIGO need to be able to measure changes in their arm lengths of order $10^{-18}~$m or smaller. This requires very high laser power in order to raise the signal above shot noise. One…
Laser frequency noise (LFN) is the dominant source of noise expected in the Laser Interferometer Space Antenna (LISA) mission, at $\sim$7 orders of magnitude greater than the typical signal expected from gravitational waves (GWs).…
A new cryogenic noise calibration source for radio astronomy receivers is presented. Dissipated power is only 4.2 mW, allowing it to be integrated with the cold part of the receiver. Measured long-term stability, sensitivity to bias…
The space-based gravitational-wave observatory LISA, a NASA-ESA mission to be launched after 2012, will achieve its optimal sensitivity using Time Delay Interferometry (TDI), a LISA-specific technique needed to cancel the otherwise…
The Hydrogen Intensity and Real-time Analysis eXperiment (HIRAX) aims to improve constraints on the dark energy equation of state through measurements of large-scale structure at high redshift ($0.8<z<2.5$), while serving as a…
The Laser Interferometer Space Antenna will detect gravitational waves with frequencies from 0.1 mHz to 1 Hz. This article provides a brief overview of LISA's science goals followed by a tutorial of the LISA measurement concept.
The phase noise of low-noise oscillators is conventionally measured by the cross-spectrum method (CSM), which has a complicated setup. We developed an alternative method called zero-crossing analysis with a double recorder setup (ZCA-DRS)…
In order to reach the sensitivity required to detect gravitational waves, pulsar timing array experiments need to mitigate as much noise as possible in timing data. A dominant amount of noise is likely due to variations in the dispersion…
We have developed a torsion pendulum facility for LISA gravitational reference sensor ground testing that allows us to put significant upper limits on residual stray forces exerted by LISA-like position sensors on a representative test mass…
Variations in the electrostatic surface potential between the proof mass and electrode housing in the space-based gravitational wave mission LISA is one of the largest contributors of noise at frequencies below a few mHz. Torsion balances…
A set of co-aligned high resolution images from the Atmospheric Imaging Assembly (AIA) on board the Solar Dynamics Observatory (SDO) is used to investigate propagating disturbances (PDs) in warm fan loops at the periphery of a non-flaring…
It was shown in a previous work that the data combinations canceling laser frequency noise constitute a module - the module of syzygies. The cancellation of laser frequency noise is crucial for obtaining the requisite sensitivity for LISA.…
The Extreme-Ultraviolet Imaging Spectrometer on board the HINODE satellite is used to examine the loop system described in Marsh et al. (2009) by applying spectroscopic diagnostic methods. A simple isothermal mapping algorithm is applied to…
The extreme weakness of the gravitational interaction has as one of its consequences that appreciable intensities of gravitational waves (GW) can only be generated in large size astrophysical and cosmological sources. Earth based detectors…
Space-borne interferometric gravitational-wave detectors, sensitive in the low-frequency (mHz) band, will fly in the next decade. In these detectors, the spacecraft-to-spacecraft light-travel times will necessarily be unequal and…
Recent clinical evidence shows a correlation between linear energy transfer (LET) and tumor control in carbon ion radiotherapy. This prompts the direct inclusion of LET into the treatment planning. Currently, LET is mainly extracted from…
A main scientific output of the LISA Pathfinder mission is to provide a noise model that can be extended to the future gravitational wave observatory, LISA. The success of the mission depends thus upon a deep understanding of the…
LISA Pathfinder's measurement of a relative acceleration noise between two free-falling test masses with a square root of the power spectral density of $5.2 \pm 0.1 \mbox{ fm s}^{-2}/\sqrt{\rm{Hz}}$ appreciably constrains collapse models.…
LISA (Laser Interferometer Space Antenna) is a proposed space mission, which will use coherent laser beams exchanged between three remote spacecraft to detect and study low-frequency cosmic gravitational radiation. In the low-part of its…