Related papers: Degradation of Ag/Si multilayers during heat treat…
We show here that the morphological pathway of spontaneous dewetting of ultrathin Ag films on SiO2 under nanosecond laser melting is found to be film thickness dependent. For films with thickness h between 2 <= h <= 9.5 nm, the morphology…
Silver films were deposited at room temperature onto H-passivated Si(111) surfaces. Their electronic properties have been analyzed by angle-resolved photoelectron spectroscopy. Submonolayer films were semiconducting and the onset of…
Based on the parameters from published ab-inito theoretical and experimental studies, and combining Molecular Dynamics (MD) and kinetic Monte Carlo (KMC) simulations, a framework of multi-scale modeling is developed to investigate the…
Kerr rotation and Superconducting QUantum Interference Device (SQUID) magnetometry measurements were performed on ultrathin (Ga$_{0.95}$Mn$_{0.05}$)As layers. The thinner layers (below 250 \AA) exhibit magnetic properties different than…
Annealing treatment is an important step of rolling deformation that contributes to microstructural evolution and leads to the significant changes in damping capacity. Damping capacities were analyzed in the parallel to rolling direction at…
Ti/Cu multilayers with periods ranging from 4 to 52.5 nm were synthesized by magnetron sputtering to examine how the period thickness affects morphology, crystallization, texture development, and preservation of periodicity. The structural…
In {\delta}-Ag2/3V2O5 with charge degrees of freedom in V, it is known that the charge ordering state and physical properties of V that appear at low temperatures depend strongly on the ordering state of Ag. In this study, we focused on the…
Pulsed laser deposition from a Nd:YAG laser was employed in production of hundreds of nanometer thick quasicrystalline Ti-Zr-Ni films on glass substrate. The influence of deposition temperature Ts on the structure, morphology and…
Amorphous hydrogenated silicon (a-Si:H) is an important material for surface defect passivation of photovoltaic silicon (Si) wafers in order to reduce their recombination losses. The material is however unstable with regards to hydrogen (H)…
Plasticity in body-centred cubic (BCC) metals, including dislocation interactions at grain boundaries, is much less understood than in face-centred cubic (FCC) metals. At low temperatures additional resistance to dislocation motion due to…
The effect of sintering regimes on the density, microstructure parameters, and mechanical properties of Al2O3 and Al2O3 + 0.25%MgO ceramics has been investigated. The ceramics were sintered in three regimes: Regime I - heating at a constant…
A combination of experimental and numerical calculations on metallic silver and platinum nanoparticles deposited on silica substrates is presented, with a focus on the metal-substrate interactions. Experimentally, the nanoparticles are…
The effect of outdiffusion of Mn interstitials from (Ga,Mn)As epitaxial layers, caused by post-growth low-temperature annealing, on their electronic- and band-structure properties has been investigated by modulation photoreflectance (PR)…
Components manufactured via Wire + Arc Additive Manufacturing are usually characterised by large columnar grains. This can be mitigated by introducing in-process cold-rolling; in fact, the associated local plastic deformation leads to a…
$Ar^+$ ion has been used regularly for the cleaning of semiconductor, metal surfaces for epitaxial nanostructures growth. We have investigated the effect of low-energy $Ar^+$ ion sputtering and subsequent annealing on the…
It was shown by computer simulation that coarsened grains with lower content of defects are formed at uniaxial deformation of a four-grain infinite nano-wire. The structure similar to crystal filaments was formed in the case of tension. The…
In this work, we experimentally establish the isothermal nanofacet evolution at an asymmetric tilt grain boundary in the Cu-Ag system using a diffusion couple approach. We investigate the nanofacet formation along the grain boundary in…
This article describes the optical properties of nanostructures composed of silver particles embedded into a gold matrix. In previous studies these materials were shown to exhibit temperature dependent transitions to a highly conductive and…
Interfaces govern the unique mechanical response of amorphous multilayers. Here, we examine nanoindentation hardness and deformation behaviour of amorphous-amorphous Ta$_2$O$_5$/SiO$_2$ nanolaminates with bilayer thicknesses ranging from 2…
Annealing of amorphous optical coatings has been shown to generally reduce optical absorption, optical scattering, and mechanical loss, with higher temperature annealing giving better results. The achievable maximum temperatures are limited…