Related papers: Microwave Dielectric Heating of Drops in Microflui…
The regulation of temperature at the macro and microscale is a major energy-consuming process of humankind. Modern cooling systems account for 15% of the global energy consumption and are responsible for 10% of greenhouse gas emissions. Due…
We theoretically study a strongly disordered superconducting layer heated by near-field microwave radiation from a nanometric metallic tip. The microwaves heat up the quasiparticles, which cool by phonon emission and conduction away from…
Water can be transitioned to an enhanced heat-conducting phase by supercooling only the water at the bottom of a container. The temperature gradient across the 4 cm in the center of an 8 cm long column of water with a 397 mW heat source at…
Electrophoresis has been shown as a novel methodology to enhance heat conduction capabilities of nanocolloidal dispersions. A thoroughly designed experimental system has been envisaged to solely probe heat conduction across nanofluids by…
Much of our knowledge about dynamics and functionality of molecular systems has been achieved with femtosecond time-resolved spectroscopy. Despite extensive technical developments over the past decades, some classes of systems have eluded…
In the present work we propose "nanofluid filled enclosures" as potential photo-thermal energy conversion and sensible heat storage devices. Herein, the optical charging of the nanofluid has been modeled as "solar radiant energy -…
Boiling heat transfer is the basis of many commonly used cooling techniques. In cooling of electronic devices, for example, it is desirable to further miniaturize heat exchangers to achieve higher heat transfer, and thus it is necessary to…
Infrared thermography is a powerful tool for studying liquid-to-vapor phase change processes. However, its application has been limited in the study of vapor-to-liquid phase transitions due to the presence of complex liquid dynamics,…
A device to measure viscosity of dielectric oils was developed. The device is an inset to an autoclave system where the temperature and the pressure could be controlled. The device is capable of measuring viscosities up to 400C and 5000psi,…
We report on microwave optomechanics measurements performed on a nuclear adiabatic demagnetization cryostat, whose temperature is determined by accurate thermometry from below 500$~\mu$K to about 1$~$Kelvin. We describe a method for…
Mitigation of hot spots in MEMS employing in situ microchannel systems requires a comprehensive picture of the maldistribution of the working fluid and uniformity of cooling within the same. In this article, detailed simulations employing…
Coalescence may not occur immediately when droplets impact a liquid film. Despite the prevalence of the high-temperature condition during the impact process in many applications, the effect of droplet temperature on droplet coalescence is…
The Leidenfrost effect, namely the levitation and hovering of liquid drops on hot solid surfaces, generally requires a sufficiently high substrate temperature to activate the intense liquid vaporization. Here we report the agile modulations…
Molecular dynamics simulations are used to study the mechanism and kinetics of hydrated electron diffusion. The electron center of mass is found to exhibit Brownian-type behavior with a diffusion coefficient considerably greater than that…
A novel micromixing technique that exploit a thrust of droplets into the mixing interface is developed. The technique enhances the mixing by injecting immiscible droplets in a mixing channel and the methodology enables a control of the…
Accurate on-chip temperature sensing is critical for the optimal performance of modern CMOS integrated circuits (ICs), to understand and monitor localized heating around the chip during operation. The development of quantum computers has…
Studies of biological solutions require high measurement accuracy, the ability to detect low changes in substance concentration, and small amounts of the liquid under test. A microwave complex permittivity measurement technique based on a…
We numerically and experimentally investigate evaporation of a sessile droplet on a heated substrate. We develop a finite element (FE) model in two-dimensional axisymmetric coordinates to solve coupled transport of heat in the droplet and…
The diffusivity of hydrogen in cold-rolled pure iron is investigated using permeation and desorption methods. Electrochemical charging, electro-permeation and thermal desorption spectroscopy (TDS) experiments are conducted. Firstly, the…
Molecular dynamics simulations are utilized to study the microwave heating of methane hydrate by the five-body rotation coordinate system with the TIP5P-Ewald model. The structure I of methane hydrate is constructed, and the ice and free…