Related papers: Resistance noise in electrically biased bilayer gr…
We present low-frequency electrical resistance fluctuations, or noise, in graphene-based field-effect devices with varying number of layers. In single-layer devices the noise magnitude decreases with increasing carrier density, which…
We present the results of the experimental investigation of the low - frequency noise in bilayer graphene transistors. The back - gated devices were fabricated using the electron beam lithography and evaporation. The charge neutrality point…
We investigate the transport properties of double-gated bilayer graphene nanoribbons at room temperature. The devices were fabricated using conventional CMOS-compatible processes. By analyzing the dependence of the resistance at the charge…
This letter investigates the bias-dependent low frequency noise of single layer graphene field-effect transistors. Noise measurements have been conducted with electrolyte-gated graphene transistors covering a wide range of gate and drain…
The nature of the low-frequency current fluctuations, i.e. carrier number vs. mobility, defines the strategies for noise reduction in electronic devices. While the 1/f noise in metals has been attributed to the electron mobility…
We report results of experimental investigation of the low-frequency noise in the top-gate graphene transistors. The back-gate graphene devices were modified via addition of the top gate separated by 20 nm of HfO2 from the single-layer…
Low-frequency 1/f noise is ubiquitous, and dominates the signal-to-noise performance in nanodevices. Here we investigate the noise characteristics of single-layer and bilayer graphene nano-devices, and uncover an unexpected 1/f noise…
We use temperature-dependent resistivity in small-angle twisted double bilayer graphene to measure bandwidths and gaps of the bands. This electron-hole asymmetric system has one set of non-dispersing bands that splits into two flat bands…
This letter investigates low frequency 1/ f noise in hBN encapsulated graphene device in a dual gated geometry. The noise study is performed as a function of top gate carrier density (nT G) at different back gate densities (nBG). The noise…
Bilayer graphene -- two coupled single graphene layers stacked as in graphite -- provides the only known semiconductor with a gap that can be tuned externally through electric field effect. Here we use a tight binding approach to study how…
A distinctive feature of single layer graphene is the linearly dispersive energy bands, which in case of multilayer graphene become parabolic. Other than the quantum Hall effect, this distinction has been hard to capture in electron…
Conductance fluctuation is usually unavoidable in graphene nanoribbons (GNR) due to the presence of disorder along its edges. By measuring the low-frequency noise in GNR devices, we find that the conductance fluctuation is strongly…
We evaluate the electronic transmission and conductance in bilayer graphene through a finite number of potential barriers. Further, we evaluate the dispersion relation in a bilayer graphene superlattice with a periodic potential applied to…
Low-frequency noise with a spectral density that depends inversely on frequency (f) has been observed in a wide variety of systems including current fluctuations in resistors, intensity fluctuations in music and signals in human cognition.…
We fabricated a large number of single and bilayer graphene transistors and carried out a systematic experimental study of their low-frequency noise characteristics. A special attention was given to determining the dominant noise sources in…
We demonstrate that the electronic gap of a graphene bilayer can be controlled externally by applying a gate bias. From the magneto-transport data (Shubnikov-de Haas measurements of the cyclotron mass), and using a tight binding model, we…
We investigate band-gap tuning of bilayer graphene between hexagonal boron nitride sheets, by external electric fields. Using density functional theory, we show that the gap is continuously tunable from 0 to 0.2 eV, and is robust to…
We measured the conductance fluctuation of bi- and trilayer graphene devices prepared on mechanical exfoliated graphene by an all-dry, lithography-free process using an ultrathin quartz filament as a shadow mask. Reproducible fluctuations…
Scattering mechanisms in graphene are critical to understanding the limits of signal-to-noise-ratios of unsuspended graphene devices. Here we present the four-probe low frequency noise (1/f) characteristics in back-gated single layer…
The tight-binding model of bilayer graphene is used to find the gap between the conduction and valence bands, as a function of both the gate voltage and as the doping by donors or acceptors. The total Hartree energy is minimized and the…