Related papers: Commissioning of the ATLAS reconstruction software…
Increasing luminosity at the Large Hadron Collider (LHC) poses a challenge for primary vertex reconstruction in the ATLAS experiment. A rate of 70 or more inelastic proton-proton collisions per beam crossing was observed during the…
This paper describes the algorithms for the reconstruction and identification of electrons in the central region of the ATLAS detector at the Large Hadron Collider (LHC). These algorithms were used for all ATLAS results with electrons in…
The ATLAS experiment at the Large Hadron Collider (LHC) at CERN is currently waiting to record the first collision data in spring 2009. Its muon spectrometer is designed to achieve a momentum resolution of 10% pT(mu) = 1 TeV/c. The…
The new CERN proton-proton collider, the LHC, is about to start in 2007 its data taking. Millions of top quarks will be available out of these data, allowing to perform a wide range of precision measurements and searches for new physics. An…
The CMS collaboration used the past year to greatly improve the level of detector readiness for the first collisions data. The acquired operational experience over this year, large gains in understanding the detector and improved…
The CMS experiment will collect data from the proton-proton collisions delivered by the Large Hadron Collider (LHC) at a centre-of-mass energy up to 14 TeV. The CMS trigger system is designed to cope with unprecedented luminosities and LHC…
The performance of the three-level ATLAS muon trigger as evaluated by using LHC data is presented. Events have been selected by using only the hardware-based Level-1 trigger in order to commission and to subsequently enable the…
The Large Hadron Collider will provide an unprecedented quantity of collision data right from the start-up. The challenge for the LHC experiments is the quick use of these data for the final commissioning of the detectors, including…
The ATLAS trigger system is based on three levels of event selection that select the physics of interest from an initial bunch-crossing rate of 40 MHz. During nominal LHC operations at a luminosity of 10^34 cm^-2 s^-1, decisions must be…
The innermost part of the ATLAS (A Toroidal LHC ApparatuS) experiment at the LHC (Large Hadron Collider) will be a pixel detector, which is presently under construction. Once installed into the experimental area, access will be extremely…
The ATLAS BPTX stations are comprised of electrostatic button pick-up detectors, located 175 m away along the beam pipe on both sides of ATLAS. The pick-ups are installed as a part of the LHC beam instrumentation and used by ATLAS for…
First LHC data have been collected and collisions at a center-of-mass energy of 7 TeV are anticipated for the next months. The commissioning of the detectors and the re-establishment of the Standard Model in the new energy regime will be…
We summarize the analysis of high-pT jets in early pp collisions recorded with the ATLAS detector. Two searches for new physics are presented: One for dijet resonances, and one for quark contact interactions. The first search sets the most…
Particle physicists at the Large Hadron Collider investigate the properties of matter at subatomic length scales by colliding together bunches of high-energy protons and observing the decay products of the collisions. ATLAS is one of two…
The ATLAS experiment at the Large Hadron Collider employs a two-level trigger system to record data at an average rate of 1 kHz from physics collisions, starting from an initial bunch crossing rate of 40 MHz. During the LHC Run 2…
This paper presents the electron and photon energy calibration achieved with the ATLAS detector using about 25 fb$^{-1}$ of LHC proton--proton collision data taken at centre-of-mass energies of $\sqrt{s}$ = 7 and 8 TeV. The reconstruction…
The algorithms used by the ATLAS Collaboration to reconstruct and identify prompt photons are described. Measurements of the photon identification efficiencies are reported, using 4.9 fb$^{-1}$ of pp collision data collected at the LHC at…
The ATLAS BPTX stations are comprised of electrostatic button pick-up detectors, located 175 m away along the beam pipe on both sides of ATLAS. The pick-ups are installed as a part of the LHC beam instrumentation and used by ATLAS for…
The simulation software for the ATLAS Experiment at the Large Hadron Collider is being used for large-scale production of events on the LHC Computing Grid. This simulation requires many components, from the generators that simulate particle…
The ATLAS detector at the LHC is equipped with dedicated systems designed for the detection of forward protons produced in diffractive and photon-induced processes. These detectors significantly extend the ATLAS physics reach. Recent…