Related papers: The CDF L2 Track Trigger Upgrade

The Phase-I trigger readout electronics upgrade of the ATLAS Liquid Argon calorimeters enhances the physics reach of the experiment during the upcoming operation at increasing Large Hadron Collider luminosities. The new system, installed…

The high instantaneous luminosities expected following the upgrade of the Large Hadron Collider (LHC) to the High Luminosity LHC (HL-LHC) pose major experimental challenges for the CMS experiment. A central component to allow efficient…

In preparation for the High Luminosity LHC, the entire tracker detector of the CMS experiment will be exchanged as part of the Phase-2 Upgrade. The new Outer Tracker will comprise approximately 13,000 silicon sensor modules, of which 7608…

The LHCb experiment will operate at a luminosity of $2\times10^{33}$ cm$^{-2}$s$^{-1}$ during LHC Run 3. At this rate the present readout and hardware Level-0 trigger become a limitation, especially for fully hadronic final states. In order…

The upgraded Large Hadron Collider beauty (LHCb) experiment is the first detector based at a hadron collider using a fully software based trigger. The first `High Level Trigger' stage (HLT1) reduces the event rate from 30 MHz to…

This paper describes the deepfake audio detection system submitted to the Audio Deep Synthesis Detection (ADD) Challenge Track 3.2 and gives an analysis of score fusion. The proposed system is a score-level fusion of several light…

The Muon Spectrometer (MS) of the ALICE experiment at LHC is equipped with a HLT (High Level Trigger), whose aim is to improve the accuracy of the trigger cuts delivered at the L0 stage. A computational challenge of real-time event…

Real-time object tracking necessitates a delicate balance between speed and accuracy, a challenge exacerbated by the computational demands of deep learning methods. In this paper, we propose Confidence-Triggered Detection (CTD), an…

The Short-Time Fourier Transform (STFT) has been a staple of signal processing, often being the first step for many audio tasks. A very familiar process when using the STFT is the search for the best STFT parameters, as they often have…

A new pixel detector for the CMS experiment is being built, owing to the instantaneous luminosities anticipated for the Phase I Upgrade of the LHC. The new CMS pixel detector provides four-hit tracking while featuring a significantly…

A significant upgrade of the LHCb detector is scheduled to be installed in 2018-2019. Afterwards all sub-detectors will be read out at the LHC bunch crossing frequency of 40 MHz and the trigger will be fully implemented in software. The…

This note describes a study of the possibilities for selecting an electron calibration stream using the High level electron trigger (Level 2 and the event filter). Using the electromagnetic calorimeter reconstruction and the track…

Over the next 6 years the CDF and D0 collaborations have the goal of collecting 15 fb-1 of data in collider Run II. This will require a number of ambitious upgrades to the Fermilab accelerator complex, some of which have been completed,…

Run II at the Tevatron Collider started at the beginning of March 2001. With extensive upgrades on both detectors and electronics the CDF II began to collect data. This paper reviews early Run II physics results obtained by analyzing data…

The CMS experiment has been designed with a two-level trigger system: the Level 1 (L1) Trigger, implemented on custom-designed electronics, and the High Level Trigger (HLT), a streamlined version of the CMS reconstruction and analysis…

The PreProcessor of the ATLAS Level-1 Calorimeter Trigger prepares the analogue trigger signals sent from the ATLAS calorimeters by digitising, synchronising, and calibrating them to reconstruct transverse energy deposits, which are then…

Physics collisions at 13 TeV are expected at the LHC with an average of 40-50 proton-proton collisions per bunch crossing under nominal conditions. Tracking at trigger level is an essential tool to control the rate in high-pileup conditions…

Single muon triggers are crucial for the physics programmes at hadron collider experiments. To be sensitive to electroweak processes, single muon triggers with transverse momentum thresholds down to 20 GeV and dimuon triggers with even…

The Pad Front End Board (pFEB) and the Strip Front End Board (sFEB) are developed for the ATLAS Phase-I sTGC Trigger Upgrade. The pFEB is used to to gather and analyze pads trigger, and the sFEB is developed to accept the pad trigger to…

The Collider Detector at Fermilab (CDF) pursues a broad physics program at Fermilab's Tevatron collider. Between Run II commissioning in early 2001 and the end of operations in September 2011, the Tevatron delivered 12 fb-1 of integrated…