Related papers: BeamLine Design for MINERvA TestBeam Detector
HERMES (High Energy Rapid Modular Ensemble of Satellites) is an innovative mission aiming to observe transient high-energy events such as gamma-ray bursts (GRBs) through a constellation of CubeSats hosting a broadband X and gamma-ray…
A special beam line for high energy electron radiography is designed, including achromat and imaging systems. The requirement of the angle and position correction on the target from imaging system can be approximately realized by fine…
Prototypes of MICROMEGAS chambers, using bulk technology and analog readout, with 1x1cm2 readout segmentation have been built and tested. Measurements in Ar/iC4H10 (95/5) and Ar/CO2 (80/20) are reported. The dependency of the prototypes gas…
In a dedicated run where protons from the Fermilab Booster were delivered directly to the steel beam dump of the Booster Neutrino Beamline (BNB), the MiniBooNE detector was used to search for the production of sub-GeV dark matter particles…
The generation of low-emittance electron beams has received significant interest in recent years. Driven by the requirements of X-ray free electron lasers, the emittance of photocathode injectors has been reduced significantly, with a…
The AMS-02 experiment plans to install a new silicon microstrip tracker layer (Layer-0) on top of the existing detector, increasing the cosmic-ray acceptance by a factor of 3. Layer-0 employs a design in which multiple silicon microstrip…
The Compact Linear Accelerator for Research and Applications (CLARA) is a 250 MeV ultrabright electron beam test facility at STFC Daresbury Laboratory. A user beam line has been designed to maximise exploitation of CLARA in a variety of…
We consider the sensitivity of fixed-target neutrino experiments at the luminosity frontier to light stable states, such as those present in models of MeV-scale dark matter. To ensure the correct thermal relic abundance, such states must…
The LHCb experiment at the European Organization for Nuclear Research (CERN) is dedicated to precision measurements of CP violation and rare decays of B hadrons. Its most sensitive components are protected by means of a Beam Conditions…
We discuss the minimum requirements for a neutrino beta beam if theta_13 is discovered by an upcoming reactor experiment, such as Double Chooz or Daya Bay. We require that both neutrino mass hierarchy and leptonic CP violation can be…
NOvA is a long-baseline accelerator-based neutrino oscillation experiment that is optimized for $\nu_e$ measurements. It uses the upgraded NuMI beam from Fermilab and measures electron-neutrino appearance and muon-neutrino disappearance at…
The main goal of a beta-beam facility is to determine the possible existence of CP violation in the lepton sector, the value of the third neutrino mixing angle and the mass hierarchy. Here we argue that a much broader physics case can be…
NOvA is a long-baseline accelerator-based neutrino oscillation experiment that is optimized for electron-neutrino appearance measurements. It uses the upgraded NuMI beam from Fermilab and consists of a Far Detector in Ash River, Minnesota…
This paper describes the concept of a primary electron beam facility at CERN, to be used for dark gauge force and light dark matter searches. The electron beam is produced in three stages: A Linac accelerates electrons from a photo-cathode…
A beam profile monitor utilizing visible synchrotron radiation (SR) from a bending magnet has been designed and installed in Cornell Electron-Positron Storage Ring (CESR). The monitor employs a double-slit interferometer to measure both the…
The MINOS Collaboration continues its search for $\nu_e$ appearance in the NuMI (Neutrinos at the Main Injector) beam at Fermilab. Neutrinos in the beam interact in the Near Detector, located 1 km from the beam source, allowing us to…
In this paper we model by using the Monte Carlo simulation code PENELOPE [1, 2] a Broad Energy Germanium (BEGe) detector and determine its efficiency. The simulated geometry consists of a point source located close to the detector as well…
A real-time beam profile monitoring system is proposed for GeV photon beams at the BM4 beamline of the Mikamine site, Research Center for Accelerator and Radioisotope Science (RARiS; previously known as ELPH) at Tohoku University. This…
A beam imaging detector was developed by coupling a multi-strip anode with delay line readout to an E$\times$B microchannel plate (MCP) detector. This detector is capable of measuring the incident position of the beam particles in…
The Multi-Purpose Detector (MPD) is to be installed at the Nuclotron Ion Collider fAcility (NICA) of the Joint Institute for Nuclear Research (JINR). Its main goal is to study the phase diagram of the strongly interacting matter produced in…