Related papers: High Voltage CMOS Control Interface for Astronomy …
Charge Coupled Devices (CCDs) have been successfully used in several low energy X-ray astronomical satellite over the past two decades. Their high energy resolution and high spatial resolution make them an perfect tool for low energy…
We have designed and built a new type of CCD that we call an orthogonal transfer CCD (OTCCD), which permits parallel clocking horizontally as well as vertically. The device has been used successfully to remove image motion caused by…
The Swift X-ray Telescope (XRT) focal plane camera is a front-illuminated MOS CCD, providing a spectral response kernel of 144 eV FWHM at 6.5 keV. We describe the CCD calibration program based on celestial and on-board calibration sources,…
The optical vortex coronagraph (OVC) is one of the promising ways for direct imaging exoplanets because of its small inner working angle and high throughput. This paper presents the design and laboratory demonstration performance at 633nm…
The design and implementation of astronomical cameras based on the large-format CCD and CMOS detectors is described in this paper. The Dinacon-5 controller is used for work with the CCDs and to achieve high performance and low noise. A new…
We present the updated design of HighSpec, a high-resolution $\mathcal{R} \sim 20,000$ spectrograph designed for the Multi Aperture Spectroscopic Telescope (MAST). HighSpec offers three observing modes centered at the Ca II H&K, Mg b…
We have built and tested a compact, low-cost, but very-high-performance astronomical polarimeter based on a continuously rotating half-wave plate and a high-speed imaging detector. The polarimeter is suitable for small telescopes up to ~1 m…
A full-wafer, 10,580 $\times$ 10,560 pixel (95 $\times$ 95 mm) CCD was designed and tested at Semiconductor Technology Associates (STA) with 9 um square pixels and 16 outputs. The chip was successfully fabricated in 2006 at DALSA and some…
Optical isolation is a long pursued object with fundamental difficulty in integrated photonics. As a step towards this goal, we demonstrate the design, fabrication, and characterization of on-chip wavelength-scale optical diodes that are…
A PC based high speed silicon microstrip beam telescope consisting of several independent modules is presented. Every module contains an AC-coupled double sided silicon microstrip sensor and a complete set of analog and digital signal…
CMOS detectors offer many advantages over CCDs for optical and UV astronomical applications, especially in space where high radiation tolerance is required. However, astronomical instruments are most often designed for low light-level…
Photonic integrated circuits are gaining traction in the field of telecommunications and information processing for their low-loss and high-throughput data transmission in comparison to electronic integrated circuits. However, they are…
A high-granularity telescope system with a large sensitive area and low material budget has been developed for high-energy heavy ion beam tests. The telescope consists of nine layers of silicon microstrip detectors (SSDs), whose performance…
High solar Photovoltaic (PV) penetration on distribution systems can cause over-voltage problems. To this end, an Optimal Tap Control (OTC) method is proposed to regulate On-Load Tap Changers (OLTCs) by minimizing the maximum deviation of…
CCDs characterization is the preliminary step to perform before the CCD can be properly used at the telescope. Most of the scientific instrumentation at the Italian National Telescope Galileo use CCDs as detectors. In particular the optical…
We describe the commissioning of a system which has been built to investigate optimal operation of CCDs for the LSST telescope. The test system is designed for low vibration, high stability operation and is capable of illuminating a…
Herein, we describe the design, implementation and operation principles of an astronomical camera system, based on a large-format CCD261-84 detector with an extremely thick 200 mkm substrate. The DINACON-V controller was used with the CCD…
The novel MPGD-based photon detectors of COMPASS RICH-1 consist of large-size hybrid MPGDs with multi-layer architecture including two layers of Thick-GEMs and a bulk resistive MicroMegas. The top surface of the first THGEM is coated with a…
This work presents the 8-channel FastIC+, a low-power consumption and highly configurable multi-channel front-end ASIC with internal digitization, for the readout of photo-sensors with picosecond time resolution and intrinsic gain. This…
ULTRACAM is a portable, high-speed imaging photometer designed to study faint astronomical objects at high temporal resolutions. ULTRACAM employs two dichroic beamsplitters and three frame-transfer CCD cameras to provide three-colour…