Related papers: An AC susceptometer for the characterization of la…
We present a new technique for measuring the critical temperature Tc in the high pressure, high Tc electron-phonon-driven superconducting hydrides. This technique does not require connecting leads to the sample. In the multiphonon region of…
Rare Earth Barium Copper Oxide (REBCO) coated conductors (CCs) have emerged for future high field magnets in fields and temperatures inaccessible for Nb based superconductors. However, their exceptionally high current densities pose…
An experimental setup for determining the electrical resistivity of several types of thermoelectric materials over the temperature range 20 < T < 550 C is described in detail. One resistivity measurement during temperature cycling is also…
A wide variety of superconducting oxides are used to test a general model of high pressure induced transition temperature (T c) changes. The T c 's vary from a low of 24 K to a high of 164 K. Although the model is capable of predicting both…
A proximity-effect thermometer measures the temperature dependent critical supercurrent in a long superconductor - normal metal - superconductor (SNS) Josephson junction. Typically, the transition from the superconducting to the normal…
A generalized model for the critical temperature Tc of superconducting bilayers is presented, which is valid with no restrictions to film thicknesses, Tc of the layers and interface resistivity. The model is verified experimentally on a…
We present two magnetometry-based methods suitable for assessing gradients in the critical temperature and hence the composition of multifilamentary superconductors: AC magnetometry and Scanning Hall Probe Microscopy. The novelty of the…
The noncentrosymmetric superconductor TaOs has been characterized using x-ray diffraction, resistivity, magnetization, and specific heat measurements. Magnetization and specific heat measurements show a bulk superconducting transition at…
We study the magnetic interaction between two superconducting concentric mesoscopic Al loops, close to the superconducting/normal phase transition. The phase boundary is measured resistively for the two-loop structure as well as for a…
The amplitude of ground state superconducting energy gap $\Delta(0)$ and relative jump in electronic specific heat at the transition temperature, $\Delta$$C$${/}$$\gamma$$T_c$, are primary fundamental parameters of any superconductor. There…
We have discovered that samples of a new material produced by special processing of crystals of Sr2RuO4 (which is known to be a triplet superconductor with Tc values ~1.0-1.5K) exhibit signatures of superconductivity (zero DC resistance and…
This work builds on the previous introduction [1] of a coupled experimental-computational system devised to fully characterize the thermal behavior of complex 3D submicron electronic devices. The new system replaces the laser-based surface…
A possible superconducting gap, about 35 meV, was observed in silicene on Ag(111) substrate by scanning tunneling spectroscopy. The temperature-dependence measurement reveals a superconductor-metal transition and gives a critical…
We investigate the electronic properties and the superconducting gap characteristics of a single crystal of hole-doped 122 Fe-pnictide Ba$_{0.65}$Na$_{0.35}$Fe$_2$As$_2$ by means of specific heat measurements. The specific heat exhibits a…
We report magnetic measurements up to 1200 K on three different multi-walled carbon nanotube mat samples using Quantum Design vibrating sample magnetometers. Three different samples prepared from arc discharge or chemical vapor deposition…
The pseudogap phase above the critical temperature of high $T_{c}$ superconductors (HTSC) presents different energy scales and it is currently a matter of intense study. The complexity of the HTSC normal state requires very accurate…
This is the report on new development of an automated precision load-based measurement setup for thermoelectric power of different types of samples in the temperature range 5 - 330 K. The problems in the old spring-based setup have been…
A sensor for thermal and thermodynamic measurements of small magnetic systems have been designed and built. It is based on a 5μm-thick suspended polymer membrane, which has a very low heat capacity (≈ 10-6 J/K at nitrogen…
Surface temperature measurements were performed with a Scanning Thermal Microscope mounted with a thermoresistive wire probe of micrometrSurface temperature measurements were performed with a Scanning Thermal Microscope mounted with a…
In mesoscopic superconductor/normal-metal/superconductor (SNS) heterostructures, it is known that the resistance of the normal metal between the superconductors has a strong temperature dependence. Based on this phenomenon, we have…