Related papers: Micromachined Inclinometer Based on Fluid Convecti…
Temperature coefficient of resistance (TCR) of a bolometer can be tuned by modifying the thermal conductance of an absorbing materials since they sense radiations via the temperature change in the absorber. However, the thermal conductance…
After the successful installation and first operation of the upgraded Inner Tracking System (ITS2), which consists of about $10\,$m$^2$ of monolithic silicon pixel sensors, ALICE is pioneering the usage of bent, wafer-scale pixel sensors…
In this paper, a novel fully 3D, microfluidic-oriented, gel-based, and low-cost highly stretchable resistive sensors have been presented. By the proposed method we are able to measure and discriminate all of the stretch, twist, and pressure…
A method for density-based topology optimization of heat exchangers with two fluids is proposed. The goal of the optimization process is to maximize the heat transfer from one fluid to the other, under maximum pressure drop constraints for…
Nanofluids are suspensions of nanoparticles in a base heat-transfer liquid. They have been widely investigated to boost heat transfer since they were proposed in the 1990's. We present a statistical correlation analysis of experimentally…
Excitons are spin integer particles that are predicted to condense into a coherent quantum state at sufficiently low temperature, and exciton condensates can be realized at much higher temperature than condensates of atoms because of strong…
Photonic integrated circuit devices can be used as refractometric opto-fluidic sensors to detect the presence of analytes in solution at low concentrations. In this work, we investigate the refractive index sensitivity of silicon nitride…
A calculation method for engine temperatures is presented. Special focus is placed on the transient and scattering boundary conditions within the combustion chamber, including fired and coasting conditions, as well as the dynamic heat…
Temperature sensors with micro- and nanoscale spatial resolution have long been explored for their potential to investigate the details of physical systems at an unprecedented scale. In particular, the rapid miniaturization of transistor…
A simple and low cost apparatus has been designed and built to measure the electrical resistivity, ($\rho$), of metal and semiconductors in 300-620 K temperature range. The present design is suitable to do measurement on rectangular bar…
Gas behavior in systems at microscale has been receiving significant attention from researchers in the last two decades [1-4]. Today, there is an enhanced emphasis on developing new experimental techniques to capture the local temperature…
A novel, to the best of our knowledge, ultralow-temperature luminescence thermometry strategy is proposed, based on a measurement of relative intensities of hyperfine components in the spectra of Ho$^{3+}$ ions doped into a crystal. A…
Resistance thermometry provides a time-tested method for taking temperature measurements. However, fundamental limits to resistance-based approaches has produced considerable interest in developing photonic temperature sensors to leverage…
We have developed a low temperature, high-resolution microwave surface impedance probe that is able to operate in high static magnetic fields. Surface impedance is measured by cavity perturbation of dielectric resonators, with sufficient…
This paper explores the implementation of a low-cost high-precision microwave oscillator sensor with an adjustable input resistance to enhance its limit of detection (LoD). To achieve this, we introduce a \textit{Z$_{2}$} branch in the…
A differential, membrane-based nanocalorimeter for general specific heat studies of very small samples, ranging from 0.5 mg to sub-{\mu}g in mass, is described. The calorimeter operates over the temperature range from above room temperature…
Accurate and efficient thermal simulations of induction machines are indispensable for detecting thermal hot spots and hence avoiding potential material failure in an early design stage. A goal is the better utilization of the machines with…
At the ultra-thin limit below 20 nm, a film's electrical conductivity, thermal conductivity, or thermoelectricity depends heavily on its thickness. In most studies, each sample is fabricated one at a time, potentially leading to…
The strategy to install Borexino's Thermal Monitoring and Management System (BTMMS) successfully stabilized the thermal environment inside the Borexino neutrino observatory, which is understood to be a necessary step to improve and minimize…
In the past, laser propagation in a fluid with heat transfer has been modeled using simplistic conduction and convection conditions yielding inaccurate predictions. Here we present a detailed numerical study describing the thermal profile…