Related papers: Three-Dimensional Grain Boundary Spectroscopy in T…
Grain boundary roughness can affect electronic and mechanical properties of two-dimensional materials. This roughness depends crucially on the growth process by which the two-dimensional material is formed. To investigate the key mechanisms…
Triple photoionization of Xe3+, Xe4+ and Xe5+ ions has been studied in the energy range 670-750 eV, including the 3d ionization threshold. The photon-ion merged-beam technique was used at a synchrotron light source to measure the absolute…
Laser powder bed fusion is a well-established additive manufacturing method that can be used for the production of net-shaped Nd-Fe-B sintered magnets. However, low coercivity has been one of the drawbacks in the laser powder bed fusion…
Recent experimental measurements of Ag impurity diffusion in the {\Sigma}5 (310) grain boundary (GB) in Cu revealed an unusual non-Arrhenius behavior suggestive of a possible structural transformation [Divinski et al., Phys. Rev. B 85,…
Surface-enhanced Raman scattering (SERS) combines analyte-specificity and single-molecule sensitivity, but its potential is limited by slow readout where sophisticated nanosensors are analysed in a serial fashion, one particle at a time. We…
We report the fabrication of single mode buried channel waveguides for the whole mid-infrared transparency range of chalcogenide sulphide glasses by means of direct laser writing. We have explored the potential of this technology by…
In this paper, a color edge detection strategy based on collaborative filtering combined with multiscale gradient fusion is proposed. The block-matching and 3D (BM3D) filter are used to enhance the sparse representation in the transform…
Three-dimensional direct laser writing via two photon polymerization is used to fabricate anti-reflective structured surfaces composed of sub-wavelength conicoid features optimized to operate over a wide bandwidth in the near-infrared range…
The experimental limitations in the signal enhancement and spatial resolution in spectroscopic imaging have been always a challenging task in the application of near-field spectroscopy for nanostructured materials in the sub-diffraction…
Chromium depletion at grain boundaries (GBs) due to selective attack is a critical issue in the molten salt corrosion of NiCr alloys. Despite the importance of GBs in this process from numerous experimental studies, most theoretical work…
Two series of Sm-, Gd-codoped aluminoborosilicate glasses with different total rare earth content have been studied in order to examine the codoping effect on the structural modifications of beta-irradiated glasses. The data obtained by…
In this study, surface-enhanced Raman scattering (SERS) spectra of different rare earth (RE) ion-citrate complexes were investigated for the first time for the qualitative classification of RE3+ ions. With the addition of RE3+ ions to…
Successful phase-matching methods for Third Harmonics Generation (THG) include phase-matching in birefringent crystal and quasi-phase-matching (QPM) in crystal with periodically poled domains. However, these methods are not feasible in some…
The X-ray brightness delivered by fourth-generation light sources strongly depends on the electron beam current and transverse emittance. Reaching higher brilliance and lower emittances are increasingly limited by intra beam scattering,…
At very fine grain sizes, grain boundary segregation can deviate from conventional behavior due to triple junction effects. While this issue has been addressed in prior work for substitutional alloys, here we develop a framework that…
Undoubtedly, Raman spectroscopy is one of the most elaborated spectroscopy tools in materials science, chemistry, medicine and optics. However, when it comes to the analysis of nanostructured specimens, accessing the Raman spectra resulting…
Raman spectroscopy is a powerful technique to characterize materials. It probes non-destructively chemical composition, crystallinity, defects, strain and coupling phenomena. However, the Raman response of surfaces or thin films is often…
This paper reports a cathodoluminescence (CL) spectroscopic study of nanogranular AlNOErx samples with erbiumcontent, x, in the range 0.5--3.6 at%. A wide range of erbium concentration was studied with the aim ofunderstanding the…
Distributed Bragg reflectors (DBRs) composed of an AlN/AlGaN superlattice were grown of Si (111) substrates. The first high-reflectance III-nitride DBR on Si was achieved by growing the DBR directly on the Si substrate to enhance the…
Large-area two-dimensional (2D) materials for technical applications can now be produced by chemical vapor deposition (CVD). Unfortunately, grain boundaries (GBs) are ubiquitously introduced as a result of the coalescence of grains with…