Related papers: An Integrated Circuit Compatible Compact Package f…
Hybrid battery thermal management systems (HBTMS) combining active liquid cooling and passive phase change materials (PCM) cooling have shown a potential for the thermal management of lithium-ion batteries. However, the fill volume of…
Integrating alkali atomic vapors with nanophotonic devices offers a scalable route to quantum technologies that leverage strong atom-photon interactions. While there have been many approaches to such integration, the general reliance on…
Due to its exceptional electronic and thermal properties, graphene is a key material for bolometry, calorimetry, and photon detection. However, despite graphene's relatively simple electronic structure, the physical processes responsible…
The ionic-liquid-gating technique can be applied to the search for novel physical phenomena at low temperatures because of its wide controllability of the charge carrier density. Ionic-liquid gated field-effect transistors are often fragile…
We present thermopneumatic pixels (TPPs), which are tactile actuators designed for rapid fabrication and straightforward integration into compact wearable and surface-based haptic systems. Each TPP converts low-voltage ($\sim$10 V)…
By coupling two nonlinear one dimensional lattices, we demonstrate a thermal diode model that works in a wide range of system parameters. We provide numerical and analytical evidence for the underlying mechanism which allows heat flux in…
We have constructed and tested a 2d position sensitive parallel-plate gas ionization chamber with scanned charge transfer readout. The scan readout method described here is based on the development of a new position dependent charge…
A method for the most efficient removal of heat, through an anisotropic composite, is proposed. It is shown that a rational placement of constituent materials, in the radial and the azimuthal variation, at a given point in the composite…
Temperature imaging of nanoscale systems is a fundamental problem which has myriad potential technological applications. For example, nanoscopic cold spots can be used for spot cooling electronic components while hot spots could be used for…
Thermoreflectance methods by picosecond pulse heating and by nanosecond pulse heating have been developed under the same geometrical configuration as the laser flash method by the National Metrology Institute of JAPAN, AIST. Using these…
We describe a sensor for the measurement of thin dielectric layers capable of operation in a variety of environments. The sensor is obtained by microfabricating a capacitor with interleaved aluminum fingers, exposed to the dielectric to be…
A prototype of a single-gap glass Resistive Plate Chamber (RPC) is constructed by the authors. To find the considerations required for better operation of the detector's gas system, we have simulated the flow of the Ar gas through the…
Modern autonomous vehicles and robots utilize versatile sensors for localization and mapping. The fidelity of these maps is paramount, as an accurate environmental representation is a prerequisite for stable and precise localization. Factor…
Cellular metabolic rate is a good indicator of the physiological state of cells and its changes, which can be measured by total heat flux accompanying metabolism. Chip calorimeters can provide label-free and high throughput measurements of…
Fluid temperature is important for the analysis of the heat transfers in thermal hydraulics. An accurate measurement or estimation of the fluid temperature in multiphase flows is challenging. This is due to that the thermocouple signal that…
The plasma panel sensor (PPS) is an inherently digital, high gain, novel variant of micropattern gas detectors inspired by many operational and fabrication principles common to plasma display panels (PDPs). The PPS is comprised of a dense…
We report the design and implementation of a point-contact spectroscopy (PCS) system integrated with a dilution refrigerator, enabling measurements down to 30 mK. The setup employs a needle-anvil geometry with a cryogenic piezo-driven…
A simple model to fit experimental data of adsorption of gases and vapours on microporous adsorbents (type I isotherms) is proposed. The main assumption is that the adsorbate phase can be divided into identical and non-interacting effective…
In this article, we are proposing a thorough analysis of the cross, and the in-plane thermal conductivity of thin-film materials based on the 3$\omega$ method. The analysis accommodates a 2D mathematical heat transfer model of a…
The majority of microelectromechanical system (MEMS) devices must be combined with integrated circuits (ICs) for operation in larger electronic systems. While MEMS transducers sense or control physical, optical or chemical quantities, ICs…