Related papers: Step-up converter for electromagnetic vibrational …
A set of power supplies (PS) with output power rated from 100 W up to 10 kW for electromagnets powering was developed. These PS have range of current tuning of 60-80 db with high accuracy (error should be less than 0,01%). Some types of…
Preinjector VEPP-5 electron linac consists of two linear accelerators on energy 300 MeV and 510 MeV and includes 14 accelerating structures [1]. First accelerating structures both linacs have increased average rate of acceleration 25-30…
This paper proposes a novel topology for grid connected photovoltaic (PV) system based on modular multilevel converter (MMC). In this topology, a PV array is connected to capacitors of each submodule (SM) of the MMC through a DC-DC boost…
Volt/var control (VVC) of smart PV inverter is becoming one of the most popular solutions to address the voltage challenges associated with high PV penetration. This work focuses on the local droop VVC recommended by the grid integration…
This paper presents an algorithm for power curtail-ment of photovoltaic (PV) systems under fast solar irradiance intermittency. Based on the Perturb and Observe (P&O) technique, the method contains an adaptive gain that is compensated in…
Current limits of harvested energy in wearables are governed by three fundamental quantities, the physical limits of available energy density in ambient powering, safety limits in intentional powering, and the size of the wearable device.…
A classic electrostatic induction machine, Cavallo's multiplier, is suggested for in situ production of very high voltage in cryogenic environments. The device is suitable for generating a large electrostatic field under conditions of very…
We analyze a heat machine based on a periodically-driven quantum system permanently coupled to hot and cold baths. It is shown that the maximal power output of a degenerate $V$-type three-level heat engine is that generated by two…
In this work, the problem of switching control design for DC-DC boost converter is considered, in the case of operation under uncertain equilibrium condition arising due to perturbations in the input and load parameters. Assuming that these…
This paper proposes an electronic circuit simulator-based method to accelerate the power system transient simulation, where the modeling of a generic HVDC (High Voltage Direct Current) system is focused. The electronic circuit simulation…
We have realized a nano-electromechanical hybrid system consisting of a silicon nitride beam dielectrically coupled to a superconducting microwave resonator. We characterize the sample by making use of the Duffing nonlinearity of the…
Multilevel converters have found many applications within renewable energy systems thanks to their unique capability of generating multiple voltage levels. However, these converters need multiple DC sources and the voltage balancing over…
The electric dipole moment (EDM) of the top quark is calculated in a model with a vector like multiplet which mixes with the third generation in an extension of the MSSM. Such mixings allow for new CP violating phases. Including these new…
The goal of this work is to minimize the energy dissipation of embedded controllers without jeopardizing the quality of control (QoC). Taking advantage of the dynamic voltage scaling (DVS) technology, this paper develops a performance-aware…
This paper present high precision halfwave rectifier circuit in dual phase output mode by 0.5 micrometer CMOS technology, plus or minus 1.5 V low voltage, it has received input signal and sent output current signal, respond in high…
This paper aims to investigate electric dynamics and improve electric power generation of an isolated wave energy converter that uses a linear permanent magnet generator as the power take-off system, excited by regular or irregular waves.…
This paper proposes a recursive, virtual admittance based, secondary controller for DG units that improves the voltage profile in distribution networks. First, the adaptation of the virtual admittance concept for the goal of voltage…
The optimal operation problem of electric vehicle aggregator (EVA) is considered. An EVA can participate in energy and regulation markets with its current and upcoming EVs, thus reducing its total cost of purchasing energy to fulfill EVs'…
The high R/X ratio of typical distribution systems makes the system voltage vulnerable to the active power injection from distributed energy resources (DERs). Moreover, the intermittent and uncertain nature of the DER generation brings new…
A Low-Power Variable Gain (VG) mm-Wave Low Noise Amplifier (LNA) is designed and simulated in a 28-nm CMOS process. The LNA utilizes a simple, yet novel, technique presented in this paper to vary the small-signal output resistance to…